Intermatic CA05500RM2, CA5500B, CA5500R Users Manual

Providing a Brighter Solution™

Model CA5500R & CA5500B

Hand-Held Remote Control & Charger Base Station

TM

WIRELESS CONTROLS

CA5500B

Specifications:

Wireless RF Control
Operating Temperature Range:
32°F (0°C) to 104°F (40°C)
Rechargeable Nickel Metal Hydride

Caution: To avoid fire or serious
damage to the remote control, use
only Intermatic CA5500BAT
replacement battery.

Ratings:

Wall-pack Transformer:
Input:120VAC, 50/60Hz;
Output 9VDC 500ma (CATRFM)

RF Information:

Minimum Range:
50ft indoor; 100ft outdoor
Frequency: 908.42 MHz

Network Information:

Mesh Network - Each line powered
node acts as a repeater to route
distant signals.
Data Rate: 9600 bits/second
Size: 232 Z-Wave™ Nodes

CA5500R

The CA5500 Remote and Base Station are
compatible with Z-wave™ enabled networks and devices.
Z-wave network is designed to act as a repeater forming a mesh network eliminating
radio “dead spots” and providing the highest level of reliability.

Features

- The CA5500B provides InTouch server function for enhanced Z-wave

™
capabilities including; extended signal hopping, full status of InTouch and legacy
Z-wave devices, system messaging, in-field firmware upgrades, advanced scene
control, and much, much, more.

- Multiple location On/Off & Raise/Lower control when used with Z-wave enabled
devices.

- Allows control of up to 9 individual pre-set scenes containing any number of Z-wave
enabled devices.

- Features individual scene status feedback for enhanced control.

- Separate focus and control buttons allows the user to custom mix scene selections
and device levels.

- Home key provides for quick de-selection of scenes.

INSTALLATION:

1. Plug included wall pack transformer into standard 120VAC receptacle.

2. Attach plug-end of cord to CA5500B base station.

3. Firmly seat CA5500R hand-held remote in base station. Indicator on base station will begin to pulse to
indicate charging. Back lights on hand-held unit will light and remain lit while in base station.

4. Charge remote for a minimum of 12 hours initially. Indicator on base station will stop pulsing when remote
is fully charged.

5. If indicator on base station turns red, a battery or communications failure is indicated. Reseat the remote in
the base, if the condition persists contact technical services.

6. Remote may be used in or out of the base station. When used as a hand-held back lights will go to sleep
20 seconds after last button press. To re-awaken, press any button on the remote.

7.

Operation: Press scene number button(s) to focus control activities; Press “Enter” to toggle selected
scene(s); Press
scene(s)

8. For programming instructions refer to the

rs/ to raise or lower selected scene(s) level; Press the home key to clear selected

enhanced radio frequency controllers

Each line powered node in a

(158CA12789).InTouch Installer & Users Guide

158CA12478REF

Providing a Brighter Solution™

Indicator LED

Scene Buttons

Enter Button

Raise & Lower
Buttons

Home Button

Base Station
Indicator LED

TM

WIRELESS CONTROLS

FCC STATEMENT OF COMPLIANCE

This device complies with part 15 of the FCC rules.
Operation of this device is subject to the following two
conditions:

(1) This device may not cause harmful
interference, and
(2) This device must accept any interference,
including interference that may cause

undesired operation.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna

or device.

-- Increase the separation between the

equipment and receiver.

-- Connect the equipment into an outlet on a

circuit different from that to which the receiver

is connected.

-- Consult the dealer or an experienced

radio/TV technician for help.

WARNING! Changes or modifications not
expressly approved by Intermatic Inc. could void
the user’s authority to operate the equipment.

LIMITED TEN YEAR WARRANTY

If within ten (10) years from date of purchase, this product fails due to a defect in material or workmanship, Intermatic Incorporated will repair or replace, at its
sole option. This warranty applies only to the original purchaser and is not transferable. This warranty excludes and this is disclaimed liability for labor for
removal of this product or reinstallation. The warranty does not apply to: (a) damage caused by accident, abuse, mishandling, dropping, acts of God, or any
negligent use; (b) units which have been subject to unauthorized repair, opened, taken apart, or otherwise modified; (c) units not used in accordance with
directions; (d) damages exceeding the cost of the product. Some states do not allow a limitation of damages, so the foregoing limitation may not apply to you.
This warranty gives you specific legal rights and you may have other rights that vary from state to state.

LIABLE FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES. THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES.
ALL IMPLIED WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS FOR A PARTICULAR
PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS
THE WARRANTY PERIOD STATED ABOVE.

This warranty service is available by either (a) returning the product to the dealer from whom the unit was purchased, or (b) mailing postage prepaid to the
nearest authorized service center listed. Please be sure to wrap the product securely when mailing to avoid shipping damage. This warranty is made by:
Intermatic Incorporated, After Sales Service, 7777 Winn Road, Spring Grove, IL 60081-9698, 815-675-7000 www.intermatic.com

INTERMATIC INCORPORATED WILL NOT BE