Intermatic C8865 Owner's Manual

Model: C8865

LR3730

REPEAT CYCLE TIMER

ACTUATING TIME - EACH TRIPPER, 30 SECONDS

SWITCH RATING: 20 AMP. 125-480 VOLTS A.C. 1/2 HP-125V 1 HP-250V.

CLOCK MOTOR VOLTAGE AND CYCLE MUST BE AS SPECIFIED. TO ORDER
REPLACEMENT, INDICATE PART NO. (WG--) ON MOTOR COVER.

TIME
POINTER

FIG. 1 WIRING DIAGRAM

CLOCK MOTOR: 125 VOLTS - 60 HZ.

WIRING INSTRUCTIONS

This Time Switch can be wired to control two circuits as single pole
double throw, or to control one circuit as single pole single throw, either
normally closed (NC) or normally open (NO). To wire Time Switch as
desired, see wiring diagram above. Use solid or stranded COPPER only
wire with insulation to suit installation. Replace insulator before turning
on electricity.

PROGRAMMING INSTRUCTIONS

1. SET PROGRAM TIME: Place tripper(s) into dial at desired time(s)

operation(s) is/are required.

 • ON TIME: First tripper turns on the load for 32-40 seconds.

Each additional tripper will lengthen the on time by 30 seconds.

• OFF TIME: First tripper omitted turns off the load for 20-28

seconds. Each additional space will lengthen the off time by 30
seconds.

2. TO SET DIAL, Turn dial in CLOCKWISE direction only. The “TIME
POINTER” indicates position at which switch action takes place.

TO REMOVE MECHANISM FROM CASE, Disconnect electricity and all
wiring. Depress retainer spring at upper left, or unscrew mounting screws,
then grasp dial and pull mechanism out.

IN CASE OF POWER FAILURE, reset dial. See step (2) of programming
instructions.

DIAL CYCLE: 1 HOUR

SINGLE POLE DOUBLE THROW

TIME
DIAL

INSULATOR

LINE

NEUTRAL

CLOCK
MOTOR

N.O.

NORM. CLOSED CIRCUIT

COM.N.C.

CLOCK

NORM. OPEN CIRCUIT

NO.

LOAD

N.C.

LOAD

INTERMATIC INCORPORATED

SPRING GROVE, ILLINOIS 60081-9698 - U.S.A.

154--00497