Page 1
INSTALLATION INSTRUCTIONS
Model AG65033/AG6503C3/AG6503L3
Type 1 or Type 2 Surge Protection Device (SPD)
IMPORTANT SAFETY INSTRUCTIONS • SAVE THESE INSTRUCTIONS
WARNING
• Disconnect power at the circuit breaker(s) or disconnect switch(es) before installing or servicing.
• Intended for indoor or outdoor use.
• Installation and/or wiring must be in accordance with national and local electrical code and/or Canadian Electrical Code requirements.
• Installation and service to be performed by a qualied licensed technician or electrician.
• Suitable for use on a circuit capable of delivering not more than 50,000 rms symmetrical amperes.
• This unit contains no serviceable parts.
AVERTISSEMENT
• L’installation et/ou le câblage doivent être conformes aux exigences du code de l’électricité local en vigueur et/ou du Code canadien de l’électricité.
• L’installation et l’entretien doivent être effectués par un technicien ou électricien qualié.
• Convient à un circuit capable de fournir PAS plus de 50 000 A efcaces symétriques.
• Cet appareil ne contient aucune pièce réparable.
Risk of Fire or Electric Shock
Risque d’incendie ou de choc électrique
NOTICE
• Thoroughly read instructions before installing SPD Unit.
• This product does not protect against lightning strikes.
Type 1 installation:
A typical installation of a type 1 SPD will be connected between the secondary of the service transformer and the line side of
the service panel. This installation is intended to be installed without overcurrent protection to the SPD.
Type 2 installation:
A typical installation of a type 2 SPD will be connected to the load side of the service panel and is intended to be installed with
overcurrent protection to the SPD.
1. Determining location:
• Ensure conductor lengths are as short and straight as possible for best performance. Do not coil excess wire. The SPD
functions best if all bends in wires are rounded, ideally to a 4” radius. Hard 90 degree bend will reduce efficiency. Cut
all leads to the correct length. Do not coil excess leads.
• Install appropriate weatherproof fittings if the unit is to be mounted outside.
• Bracket part number AG1BRKT is also available if needed.
2. Connect wires as shown within diagrams. If your application does not match one of the diagrams below consult your
supplier.
3. Ensure all mounting and electrical connections are correct and securely fastened. Once energized the green indicator
LED will be ON.
Maintenance:
• AC Voltage SPD:
• Periodically check SPD to ensure green indicator LED is ON. If green LED is OFF, protection has diminished and the
SPD should be replaced immediately.
347/600 VAC WYE 3 PHASE
Line
Line
Line
Neutral/Grounded
600 V
600 V
600 V
347 V
347 V
347 V
WHITE
600 VAC Three wire plus Ground
Found at Service Entrances and
Meter Cabinets.
BLACK
BLACK
BLACK
Line
BLACK
BLACK
BLACK
WHITE
Line
Line
Neutral
Ground
600 V
600 V
600 V
347 V
347 V
347 V
347/600 VAC Four wire plus Ground
Found in Main Disconnect Switches,
Main Distribution panels, Load Centers
Sub panels and equipment locations.
Page 2
ONE YEAR LIMITED PRODUCT WARRANTY
For
INTERMATIC SURGE PROTECTIVE DEVICES
(1) What is Covered By This Limited Warranty
Replacement of Product
Intermatic Incorporated (“Intermatic”) warrants to the original purchaser only, Intermatic AG Series Surge Protective Devices (each a
“Product”) shall be free from defects in material or workmanship for a period of one year (12 months) from date of purchase or 18 months
from date of manufacture. If the purchaser discovers a defect in material or workmanship, the purchaser must promptly submit a warranty
claim. Upon a determination by Intermatic that the Product is defective, Intermatic, at its sole option shall correct any defect in material or
workmanship by replacing the Defective Product at Intermatic’s expense. The foregoing remedy is the purchaser’s exclusive remedy for a
breach of warranty.
The product must be installed in the appropriate application in complete accordance with the installation instructions. All building wiring and
other connections to the Product must conform to all applicable national, state, and local electrical codes; the Product must not be opened,
modified, exposed to extreme heat or cold, submerged or subjected to abnormal use or service. All products must be used in accordance
with the instructions provided with the Product and the purchaser shall be solely responsible for selecting a Product model with specifications
appropriate for the equipment to be protected. Intermatic shall determine, in its sole discretion, whether any Product returned by a purchaser
has been used in accordance with its instructions, is an appropriate model for the purchaser’s use thereof, and whether the Product is defective.
(2) What is Not Covered By This Warranty
Intermatic does not warrant (a) defects in the Product or damage to any equipment caused by the failure to properly install the Product, (b)
damage caused by use of the Product for purposes other than those for which it was designed, (c) damage caused by disaster such as fire,
flood and wind, (d) damage caused by unauthorized attachments or modification of the Product, (e) damage to the Product occurring during
the shipment, (f) electrical disturbances exceeding published product specifications, (g) damage to the Product caused by any other abuse
or misuse by the purchaser, or (h) damage due to direct or vicinity lightning strikes. This warranty applies to residential and commercial
applications. This device is not intended to provide protection during Utility voltage swells or loss of neutral conditions which are by
definition not transient events and are not covered by this warranty.
(3) Disclaimer of Warranty
THE FOREGOING WARRANTIES ARE IN LIEU OF ALL OTHER EXPRESSED WARRANTIES. TO THE EXTENT ALLOWED BY LAW, ANY
IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION OF THIS
LIMITED WARRANTY.
(4) Limitation of Remedies
IN NO CASE SHALL INTERMATIC BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES BASED UPON BREACH
OF WARRANTY, BREACH OF CONTRACT, NEGLIGENCE, STRICT TORT, OR ANY OTHER LEGAL THEORY. SUCH EXCLUDED DAMAGES
INCLUDE, BUT ARE NOT LIMITED TO, DAMAGE TO SOFTWARE, LOSS OF DATA, LOSS OF PROFITS, LOSS OF SAVINGS OR REVENUE, LOSS
OF USE OF THE PRODUCT OR ANY ASSOCIATED EQUIPMENT, COST OF CAPITAL, COST OF ANY SUBSTITUTE EQUIPMENT, FACILITIES
OR SERVICES, DOWNTIME, THE CLAIMS OF THIRD PARTIES INCLUDING CUSTOMERS, DAMAGE TO PROPERTY AND PERSONAL INJURY.
SOME STATES DO NOT ALLOW LIMITS ON WARRANTIES OR ON REMEDIES FOR BREACH IN CERTAIN TRANSACTIONS, IN SUCH STATES,
THE LIMITS IN THIS PARAGRAPH AND IN PARAGRAPH (3) MAY NOT APPLY.
(5) Time Limit for Bringing Suit
No action arising out of any claimed breach of warranty may be brought more than one year after the cause of action has occurred.
(6) No Other Warranties
Unless modified in writing signed by both parties, this agreement is understood to be the complete and exclusive agreement between the
parties, superseding all prior agreements, oral or written, and all other communications between the parties relating to the subject matter of
this agreement. No employee of Intermatic or any other party is authorized to make any warranty in addition to those made in this agreement.
This warranty is made by: Intermatic Incorporated/After Sales Service, 12429 Rojas Drive, EL Paso, TX 79928-5201/815-675-7000
http://www.intermatic.com
INTERMATIC INCORPORATED
SPRING GROVE, ILLINOIS 60081-9698
http://www.intermatic.com
158--01692
Loading...