Intermatic 158TS10994 User Manual

158TS10994 8/6/04 10:54 AM Page 1

MODEL: T51211BC

TWO CIRCUIT SEVEN DAY
TIMING CONTROL CENTER WITH
SPRING-WOUND CARRY-OVER MOTOR

CIRCUIT A: PHOTO CONTROL ON-TIME SWITCH OFF
CIRCUIT B: PHOTO CONTROL ON-PHOTO CONTROL OFF

CONTACT RATINGS:

15 AMP., 1/2 H.P. - 125 OR 250 VOLTS A.C.
420 V.A. PILOT DUTY, 150 WATTS TUNGSTEN -120V A.C.

TO CONTROL MECHANICALLY HELD AND MAGNETIC CONTACTORS

(MAY ALSO BE USED WITH 24 VOLT SYSTEMS IF WIRED IN ACCORDANCE
WITH NATIONAL ELECTRICAL CODE REGULATIONS.)

CLOCK MOTOR AND PHOTO CONTROL: 120 VOLTS - 60 HZ.

LR3730

WIRING INSTRUCTIONS

This center can be programmed to control any lighting and other loads on two circuits, on a
seven day schedule with selected day(s) of the week omitted from circuit
markings refer to diagram above. Follow national or local electrical code regulations and
complete wiring as shown. Turn selector switches (bottom front panel) to
before turning on electricity

PROGRAMMING INSTRUCTIONS

1. THE PHOTO CONTROL (INSTALLED OUTSIDE)

of season. If fine adjustment is needed move slide on photo control to retard/advance

"ON" time.

2. TO SET "OFF" TIMES Place dark OFF trippers firmly against dial edge at day-of-week

and time-of-day when lights are to turn of
OFF tripper on dial must be followed by an ON tripper. Fasten a bright ON tripper to dial
at any time within the day-light hours of winter, preferably 12 o'clock noon.

O SKIP

T

3.

not required (Circuit B is independently controlled by the photo control).

4. TO SET DIAL TO TIME-OF-DAY turn dial clockwise and align the exact day-of-week

and time-of-day (AM or PM) on dial with the time pointer. Some allowance may be
required to compensate for gear backlash.

wise or move time pointer.

OPERA

1. THE THREE POSITION SELECTOR SWITCH

When turned to
manually reset. W
program of the center

2. IN CASE OF EXTENDED POWER FAILURE OR NEED TO ADVANCE/RETARD TIME

place selector switch in OFF position. Reset time-of-day, see step 4 of programming
instructions. Then turn selector switch to

158TS10994

YS ON CIRCUIT

DA

TING INSTRUCTIONS

ON or OFF, lights or other loads will remain ON or OFF until the switch is

ith a switch in AUT

BEFORE ANY BEHIND-THE-PANEL WORK DISCONNECT ELECTRICITY

est each circuit individually

T

.

f. NOTE: In order to reset time switch, every

A,

omit trippers for the day(s) automatic operation(s) is/are

CAUTION: Do not force dial counterclock-

TIC

.

INTERMATIC INCORPORATED

SPRING GROVE, ILLINOIS 60081-9698

OMA

ON or AUTOMATIC.

.

selects the "ON" times depending on time

provide manual control of the two circuits.

position, operations will follow the preset

A. For terminal

OFF. Replace panel