Inter-lux i-LED linea light SUELO-R 13W, i-LED linea light SUELO-RJ 13W, i-LED linea light SUELO BLADE 13W Installation Instructions Manual

LED-FGI455-E
INSTALLATION INSTRUCTIONS
SUELO-R 13W // SUELO-RJ 13W SUELO BLADE 13W
1.A
TOOL NOT INCLUDED
OK
15°/30°/60°/00° : FIXED 15°/30°/60° : TILTING
A
SCRWES INCLUDED
1.B
ASYMMETRIC : FIXED BLADE: 5°
B
OK
TOOL NOT INCLUDED
SCREWS INCLUDED
CURROGATED PIPE
2.A
SECONDARY CABLE INCLUDED
CONCRETE
OUTERCASING COD. E84933
GROUND
DRAINAGE LAYER MIN 7,87" - 11,81"
3.A
UNSCREW SLIGHTLY THE
1
TO FACILITATE TILTING
2
CURROGATED PIPE
SCREW
SECONDARY CABLE INCLUDED
CONCRETE
O 0,9"
OUTERCASING COD. E84932
GROUND
DRAINAGE LAYER MIN 7,87" - 11,81"
4.A
UNSCREW THE FLANGE AND REMOVE THE GLASS
Revisione: - Data di creazione :27/11/2015 - Data ultima modifica : 27/11/2015
TIGHTEN THE SCREW
3
INSERT THE GLASS AND TIGHTEN THE FLANGE
Pag. 1
6,7"
OUTERCASING COD.E84933
6,7"
B
OUTERCASING COD.E84932
SECTION B-B
A
SECTION A-A
6,1"
A
5,3"
9,4"
B
5,1"
O 0,9"
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED
M
OUNTING INSTRUCTIONS
READ ALL OF THESE INSTRUCTIONS BEFORE INSTALLING FIXTURES
· Keep all of the instructions for future reference
· Turn off power before installing fixture
· Installation is to be performed by a qualified electrician only
· All installations must conform to the National Electrical Code as well as all local jurisdictional codes and regulations
· Any modification of the luminaire will void any and all written or implied warranties
· The manufacture accepts no responsibility for damage to persons or property airing through improper use or installation INSTALLATION SEQUENCE
- Mount remote driver in accessible well ventilated space
- Ensure power is off before connecting driver to line voltage
- Fix the outercasing on the ground, the surface must be perfectly flat
- Connect secondary wiring to fixture wiring
- Insert the Suelo into the outercasing and fix it with the screws [1.A-1.B]
- WARNING - Be sure secondary wiring is connected to driver BEFORE energizing to avoid LED failure
- Energize S
EQUENCE FOR ADJUST TILTING
- Ensure power is off before opening the Suelo
- Unscrew the flange and remove the glass [2.A]*
- Unscrew slightly the screw to facilitate tilting, adjust the tilting and tighten the screw [3.A]
- Insert the glass and tighten the flange [4.A]**
- Energize
* Only for Suelo Stainless Steel finish, unscrew the ring, remove the flange and the glass ** Only for Suelo Stainless Steel finish, insert the glass, insert the flange and tighten the ring
Colours Secondary Cable Pole
Wire black number 1 + Wire black number 2 -
W
ire green Ground
Pag. 2
Loading...