Interlogix WMC251-1W-2T-150 Quick Start Guide

IFS WMC251-1W-2T-150 Quick Start Guide

2. Users MUST use the “Power cord and PoE Injector”

Content

Package Contents 1
Physical Introduction 1
Hardware Installation 2
Wired Network Connection (Windows 7) 2
Web Management 3
Wireless Network Connection Error! Bookmark

not defined.

More Information 3
Contact information 3

This is the IFS WMC251-1W-2T-150 Quick Start Guide. This
document provides basic instructions for installing and using
the IFS WMC251-1W-2T-150.

shipped in the box with the WMC251-150. Use of other
options will cause damage to the WMC251-150.

Physical Introduction

Rear Panel Description – LED Indications

Package Contents

Thank you for choosing IFS WMC251-150. Before installing
the AP, please verify the contents inside the box.

The WMC251-150 should contain the following items in the
package:

• The IFS WMC251-1W-2T-150 x 1

• Quick Installation Guide x1

• PoE Injector and Power adapter x1

• Plastic strap x 1

If any item is found missing or damaged, please contact your
local reseller for replacement.

Installation Precautions

1. Users MUST use a proper and well-installed surge
arrestor and grounding wired with the WMC251-150;
otherwise, a sudden lightning could cause fatal damage to
the WMC251-150. (Lightning) DAMAGE IS NOT

COVERED UNDER WARRANTY.

Bottom Panel Description – Ports

P/N 1073052 • REV A • 11SEP15 1

Reset: Press and hold the button for more than 10 seconds to
reset to the factory default settings.

Hardware Installation

Follow the steps below to install the WMC251:

1. Push the latch on the bottom of the WMC251-150 to
remove the sliding cover.

2. Plug the RJ45 Ethernet cable into the PoE LAN Port of the
WMC251-150. Then, slide back the cover of the WMC251­150 to finish the installation.

3. Plug the power cord into the DC port and the other side
into the AC socket. Then, plug the RJ45 cable (as shown
in picture 4 under Step 1) into the POE port of the PoE
injector.

Pole Mounting

Place the strap through the slot on the back of the WMC251­150 and then around the pole. Tighten the strap to secure the
WMC251-150.

Wired Network Connection (Windows 7)

Connect the WMC251-150 with your PC by an Ethernet cable
plugging in LAN port of PoE injector in one side and in LAN
port of PC in the other side. Power on the WMC251-150 by
PoE from PoE injector.

1. Click “Start” button located at the lower-left corner of your
computer.

2. Click “Control Panel”.

3. Double click “Network and Sharing Center” icon.

4. Click “Change Adapter Settings”.

5. Double click “Local Area Connection”.

6. Select “Internet Protocol Version 4(TCP/IPv4)” and click
“Properties”.

7. Select “Use the following IP address”and then click “OK”
button twice to save the configuration. For example, as the
default IP address of the WMC251-150 is 192.168.0.100
and the router is 192.168.0.254, you may choose from

192.168.0.1 to 192.168.0.252.

2 IFS WMC251-1W-2T-150 Quick Start Guide