Interlogix UVD-IP-XP4DNR-VA2, UVD-IP-XP4DNR-VA9 Quick Start Manual

UltraView IP XP4 Dome
Day/Night Range Camera
Quick Start

Guide

P/N 1072567B-EN • REV 1.0 • ISS 23JUL12

EN 2 UltraView IP XP4 Dome Day/Night Range Camera

Introduction

The UVD-IP-XP4DNR(-P) color video camera uses a digital signal
processor (DSP) to process video signals. The video camera includes
a microcontroller to provide high-quality images in changing lighting
environments with high-color reproduction and sharp pictures.

Product codes:

• UVD-IP-XP4DNR-VA2(-P)

• UVD-IP-XP4DNR-VA9(-P)

Package contents

The UVD-IP-XP4DNR(-P) camera is shipped with the following items:

• The camera assembly

• 1 channel passive video transceiver

• AC power wiring harness

• Mounting screws, wall anchors, and hex key

• 150 mm DC jack to terminal adapter

Installation environment

To install the camera you will need to prepare the mounting surface,
make cable connections, and mount the camera.

Cable requirements

Cable type Requirements

Video 75 ohm RS-59 coaxial cable with BNC ends

Power 24 VAC cable

Network RJ45 Ethernet cable

UltraView IP XP4 Dome Day/Night Range Camera 3 EN

Camera description

Figure 1: Camera assembly

Camera body

RJ45 Ethernet/PoE input

24 VAC / 12 VDC input
Video output (BNC)



Plenum-compliant cabling

The cable connections must be enclosed in a suitable metallic, or other
fire-resistant, low-smoke producing enclosure. The cabling used within
the air space must be specifically marked for that purpose or enclosed
in a conduit.

Re-route the leads from the camera so they exit from the threaded
knockout on the side of the camera (see Figure 2 on page 4). Move
the plug from the side threaded knockout and place it on the knockout
on the base of the camera.