Interlogix TVP-PAS User Manual

TVP-PAS Stainless Steel PTZ Pendant Mount

Dimensions Weight:

Drill template:

Mounting

Expansion

Used to install the TV mounting

55 mm

17 in.)

80 mm (3.15 in.)

(0.79 in

1.2 mm

(0.05 in.)

8 mm

(

.31 in.)

M10 mm

(0.39 in.)

16 mm

(0.63 in.)

Nut

Used to mount the pipe assembly to the mounting plate

Nut:

Flat washer:

Split washer:

Installation Instructions

anchors: M10 x 80 mm (4 pcs)

Specifications

surface.

160 × 160 × 342 mm (6.30 × 6.30 × 13.46 in.)

(4 pcs), flat washer (4 pcs), and split washer (4 pcs) A

P-PAS stainless pendent mount to the

1.89 kg (4.17 lbs.)

ccessories:

1 pcs

plate : 1 pcs

Supported cameras

The stainless steel pendent mount can be used with following cameras:

Stainless Steel PTZ Dome: TVP-5201

Installation

To install the stainless steel PTZ dome to the TVP-PAS:

1. Using the drill template mark the mounting surface. Drill four mounting holes and insert the expansion anchors.

2. Secure the mounting plate to the mounting surface using the expansion anchors.

3. Route the PTZ cable assembly through the pendant mount

Trademarks and patents

Manufacturer

Certification

Product warnings

and disclaimers

For more information on warranty disclaimers and

Contact

information and manuals

or contact information go to: www.interlogix.com

pipe.

4. Using the hex wrench that is included with the stainless steel PTZ, loosen the two hex head screws (2) on the pipe (see figure in step 6).

5. To install the PTZ to the pendant mount, line up the flat

section of the metal ring (cable harness) at the top of the PTZ with the safety lanyard screw on the pendant mount. Once the PTZ is up against the end of the pendant mount, rotate the PTZ 45 degrees. Tighten down the two hex screws to secure the PTZ in place.

6. Attach the safety lanyard (1) between the PTZ and the pendant mount.

Legal and regulatory information

The trade names used in this document may be trademarks or registered trademarks of the manufacturers or vendors of the respective products.

Interlogix.

2955 Red Hill Avenue, Costa Mesa, CA 92626 5923, USA

Authorized EU manufacturing representative:

UTC Fire & Security B.V. Kelvinstraat 7, 6003 DH Weert, The Netherlands

THESE PRODUCTS ARE INTENDED FOR SALE TO AND INSTALLATION BY QUALIFIED PROFESSIONALS. UTC FIRE & SECURITY CANNOT PROVIDE ANY ASSURANCE THAT ANY PERSON OR ENTITY BUYING ITS PRODUCTS, INCLUDING ANY “AUTHORIZED DEALER” OR “AUTHORIZED RESELLER”, IS PROPERLY TRAINED OR EXPERIENCED TO CORRECTLY INSTALL FIRE AND SECURITY RELATED PRODUCTS.

product safety information, please check www.firesecurityproducts.com/policy/productwarning/ or scan the following code:

7. Align the mounting base of the pendant mount with the standoffs on the mounting plate. Rotate the pendant mount base/pipe in the direction shown to lock the assembly in place. Use the nut and washers A to secure the pipe to the mounting plate.

or www.firesecurityproducts.com

To get translations for this and other product manuals go to: www.firesecurityproducts.com

2 / 2 P/N 1073414A-EN • REV B • ISS 24APR18