Interlogix TruVision TVD-2402, TruVision TVD-4402, TruVision TVD-2404, TruVision TVD-2405, TruVision TVD-4404 Installation Manual

TruVision High

Definition TVI

Vandal Dome Installation

Guide

TVD

-2402/TVD-4402

TVD

-2404/TVD-4404

TVD-2405/TVD-4405

P/N 1073166-EN • REV B • ISS 26MAY17

Installation Guide 3

Content

Product overview 4
Camera description 6
Installation 9
Operating temperature range 14
Program 14

Setup menu 19
Specifications 21
Legal and Regulatory information 23

4 Installation Guide

Product overview

This is the Installation Guide for the TruVision High
Definition TVI dome TVD-2402/TVD-4402，TVD­2404/TVD-4404 and TVD-2405/TVD-4405. This
guide describes a standard installation.

Package contents

 Camera with power

and video output
cables

 4 screws and 4

anchors for wall or
ceiling installation

 Template

 3 screws to install

the camera to the
back box

Installation Guide 5

 Hex wrench

 Monitor output

cable

 Spare rubber

knockout

There is a rubber knockout
on the camera back box.
This is for future use.

 Installation Guide

 CD

• WEEE and Battery
Disposal sheets

6 Installation Guide

Camera description

TVD-2402/TVD4402:

1. Dome liner

2. Bubble

3. Lens

4. Power cable

5. CVBS video output
cable (black)

6. TVI video output
cable (grey)

7. Back box

8. Switch (Left =

WDR / Right =
CVBS)

9. Menu button

10. CVBS output port

Installation Guide 7

TVD-2404/4404 and TVD2405/4405:

1. Dome liner

2. Bubble

3. Lens

4. Power cable

5. CVBS video output
cable (black)

6. TVI video output
cable (grey)

7. Back box

8. Switch (Left =

WDR / Right =
CVBS)

9. Menu button

10. CVBS output port

8 Installation Guide

Note:

Please check the camera output settings

before setting up a system. The TVI video
output can be only connected to DVR with
TVI signal input. The CVBS output supports a
standard CVBS monitor (or test monitor), an
encoder or a DVR.

For 720P Dome cameras TVD-2402/TVD-

4202, the CVBS and TVI output can not be

used at the same time. Use the built-in switch
to select the camera video output.

For 1080P Dome cameras TVD-2404/TVD­4404 and TVD-2405/TVD-4405, use the built­in switch to enable/disable the WDR feature.
When the WDR feature is enabled, the CVBS
output will be blocked.

Installation Guide 9

Installation

To install the camera on a ceiling:

1. Using the template, place it level against the
mounting surface and mark the position of the
mounting holes.

2. Following all local safety regulations, drill and
prepare the mounting holes.

3. Remove the camera from its back box.

4. Loosen the three screws on the edge of the
bubble with the supplied hex wrench.

5. Remove the bubble and the dome liner.