Installation/Operation Instructions
DFAMMF01-TX/RX
DFASMF01-TX/RX
DFASMLF01-TX/RX
DFAMMD01-TX/RX
DFASMD01-TX/RX
DFASMLD01-TX/RX
DFAMMF04-TX/RX
DFASMF04-TX/RX
DFASMLF04-TX/RX
DFAMMD04-TX/RX
DFASMD04-TX/RX
DFASMLD04-TX/RX
Page 1/ 9
Literature Part number
Dip switch setting and pin connections
Audio type
SW Balance Un-Balance
3 ON OFF
4 OFF ON
SW1 & SW2 are not applicable in this model
Page 2/ 9
Audio type
PIN
1 Ground Ground
2 Audio Input+ N/C
3 Audio Input- N/C
4 N/C Audio Input+
5 Audio Input+ N/C
6 Audio Input- N/C
7 N/C Audio Input-
*N/C: No connection
Balance Un-Balance
Transmitter
LED Indicators
Indicator Color Description
PWR Red Lit when power is supplied to the Transmitter.
Red Lit when fiber is not connected or without proper fiber connection. OL
Green1 Lit when optical signal from receiver to transmitter is active.
IN Green
AUDIO2
AUDIO13
AUDIO2
AUDIO3
AUDIO4
OUT4 Green
Signal Ports
OPT - ST (or FC) Optical Connector for fiber cable connection.
AUDIO5 - 7-pin Screw Terminal Block for audio signal.
AUDIO1-46- 7-pin Screw Terminal Block for audio signal.
At front panel: Blinks when forward input audio is available at Tx.
At rear panel:
a) Each audio channel has a single column of Four LEDs
assigned for displaying the input or output audio levels.
b) The LEDs (Input/Output) are lit in proportion to the signal
strength.
At front panel: Blinks when reverse output audio is available at
Tx.
At rear panel:
a) Each audio channel has a single column of Four LEDs
assigned for displaying the input or output audio levels.
b) The LEDs (Input/Output) are lit in proportion to the signal
strength.
1
Not available for the DFAMF0-T (i.e. DFASMF01-T)
2
AUDIO is only for the products with ONE audio channels (i.e. DFASMD01-T)
3
AUDIO 1-4 is only for the products with FOUR audio channels (i.e. DFASMD04-T)
4
Not available for the DFAMF0-T (i.e. DFASMF01-T)
5
AUDIO is only for the products with ONE audio channels (i.e. DFASMD01-T)
6
AUDIO 1-4 is only for the products with FOUR audio channels (i.e. DFASMD04-T)
Page 3/ 9