Interlogix 1038 User Manual

GE Magnetic Contacts

1038 Series

Surface Mount with Wire Leads

Gap Distance Closed Loop

1" 1038

Color
Quantity

White, Mahogany Brown
10

100% TESTED

1038-N

1038 Series

Surface Mount with Wire Leads

Installation Instructions

1. Clean mounting surfaces with alcohol pad (included).

2. Align and attach mounting plates for the switch and magnet using tape or screws (included).
Wire may be routed on either end or through the top of the switch housing cutouts.

3. Strip loop wire and connect the leads to the alarm loop.

4. Place switch and magnet covers over the center of the mounting plates and slide either left or
right until the cover snaps in place.

2.26"

.38"

(0.95cm)

.40"

(1.00cm)

UL Specifications

Part Loop Electrical Gap

Number Type Configuration Distance

1038 Closed N.O. 1"

*

Gap Specifications are nominal and may vary ±20%. Gap Specifications are for switch to make.
Break distance is approximately 1.1 to 1.5 times make.

WARNING: Each electrical rating is an individual maximum and cannot be exceeded!

**

FORM A (1038)

Voltage: 100 V AC/DC max
Current: 0.5 A max
Power: 7.5 W max

(5.74cm)

1.63"

(4.13cm)

*

www.GE-InterlogixSecurity.com 2266 Second Street North

1038696 Rev A 07/02

12345 SW Leveton Drive
Tualatin, OR 97062
Phone: [phone]
USA & Canada: 800-547-2556
Technical Service: 800-648-7424
Faxback: 800-483-2495

North St. Paul, MN 55109
Phone: [phone]
USA & Canada: 800-777-5485
Technical Service: 800-777-2624

Made in Taiwan

GE Interlogix