Interglobe Connection EKOSG50E User Manual

EKO St ar 5.0E

FCC Statement

1. This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful
interference.
(2) This device must accept any interference
received, including interference that may cause
undesired operation.

2. Changes or modifications not expressly
approved by the party responsible for compliance
could void the user's authority to operate
the equipment.
NOTE:
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation.
This equipment generates uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no guarantee
that interference will not occur in a particular

installation. If this equipment does cause harmful
interference to radio or television reception, which
can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV
technician for help.
SAR Information Statement
Your wireless phone is a radio transmitter and
receiver. It is designed and manufactured not to
exceed the emission limits for
exposure to radiofrequency (RF) energy set by the
Federal Communications Commission of the U.S.
Government. These limits are
part of comprehensive guidelines and establish
permitted levels of RF energy for the general
population. The guidelines are based on
standards that were developed by independent

scientific organizations through periodic and

thorough evaluation of scientific studies.
The standards include a substantial safety margin
designed to assure the safety of all persons,
regardless of age and health. The
exposure standard for wireless mobile phones
employs a unit of measurement known as the
Specific Absorption Rate, or SAR. The
SAR limit set by the FCC is 1.6 W/kg. * Tests for
SAR are conducted with the phone transmitting at
its highest certified power level in
all tested frequency bands. Although the SAR is
determined at the highest certified power level, the
actual SAR level of the phone
while operating can be well below the maximum
value. This is because the phone is designed to
operate at multiple power levels so
as to use only the power required to reach the
network. In general, the closer you are to a
wireless base station antenna, the lower the
power output. Before a phone model is available
for sale to the public, it must be tested and certified
to the FCC that it does not
exceed the limit established by the government
adopted requirement for safe exposure. The tests
are performed in positions and
locations (e.g., at the ear and worn on the body) as

required by the FCC for each model. The highest
SAR value for this model phone
when tested for use at the ear is 0.811W/Kg and
when worn on the body, as described in this user
guide, is 0.272W/Kg(Body-worn
measurements differ among phone models,
depending upon available accessories and FCC
requirements). The maximum scaled
SAR in hotspot mode is 0.493W/Kg. While there
may be differences between the SAR levels of
various phones and at various
positions, they all meet the government
requirement for safe exposure. The FCC has
granted an Equipment Authorization for this
model phone with all reported SAR levels
evaluated as in compliance with the FCC
RFexposure guidelines. SAR information on this
model phone is on file with the FCC and can be
found under the Display Grant section of
http://www.fcc.gov/ oet/fccid after searching
on
FCC ID: 2AC7IEKOSG50E Additional information
on Specific Absorption Rates (SAR) can be found
on the Cellular
Telecommunications Industry Asso-ciation (CTIA)
web-site at http://www.wow-com.com. * In the

United States and Canada, the SAR
limit for mobile phones used by the public is 1.6
watts/kg (W/kg) averaged over one gram of tissue.
The standard incorporates a substantial
margin of safety to give additional protection for
the public and to account for any variations in
measurements.
Body-worn Operation
This device was tested for typical body-worn
operations. To comply with RF exposure
requirements, a minimum separation distance
of 10mm must be maintained between the user’s
body and the handset, including the antenna.
Third-party belt-clips, holsters, and
similar accessories used by this device should not
contain any metallic components. Body-worn
accessories that do not meet these
requirements may not comply with RF exposure
requirements and should be avoided. Use only the
supplied or an approved antenna.