PLEASE! DO NOT RETURN THIS
PLEASE! DO NOT RETURN THIS
PRODUCT TO ANY RETAIL STORE!
PRODUCT TO ANY RETAIL STORE!
10+
Item# 44054
TM
For any questions or problems with this product please contact us at:
Email: info@interactivetoy.com
Phone: Inside North America: +1-416-444-6873
Outside North America: 1-866-214-2220
Address: Interactive Toy Concepts,
17 Vulcan Street, Toronto, Ontario, Canada. M9W 1L3
Web site: www.interactivetoy.com
REPLACING ALIEN HUNTER MAIN WINGS
You can replace the original wings on your ALIEN HUNTER if they become damaged. A new set of wings can be purchased by
contacting Interactive Toy Concepts listed above.
To replace the wings, do the following:
1. Make sure the Alien and the Blaster are turned off.
2. Gently remove the far corner of the wing that is tethered to the body by a ball joint.
3. The leading (front) edge of the wing is a thin carbon fiber rod. Gently pull this rod out of the gear box mechanism housing at
the front.
4. Installation of the new wing is the reverse of the wing removal procedure with the following minor difference.
5. The carbon fiber rod has a slight notch cut into its end so that it will only fit properly into gear box mechanism housing one way. Use
caution when inserting the carbon fiber rod. If it is not going in smoothly, it is misaligned.
IMPORTANT SAFETY INFORMATION
Do not modify your ALIEN HUNTER. Do not use in strong winds, use only in VERY mild conditions! Do not use in rain, snow or around heavy
debris! Do not use near electrical lines! Do not use around smoke or flames! Do not use around water! Do not use around electricity! Do not use
in crowded areas! Do not use around air conditioning! Do not use around air vents! Do not use around ceiling fans! Do not use around large
obstacles! Do not use in very small spaces! Do be conscious of changes in your area! Any changes or modifications to this product are strictly
prohibited and will void product warranty. Keep moving wings away from eyes, hands, hair and loose clothing. Always turn off your ALIEN
HUNTER and Infrared Laser Blaster when not in use. Always remove batteries from Infrared Blaster during storage. Always replace Infrared
Blaster with NEW alkaline batteries for optimal performance. Keep your instruction manual in a safe place for future use. Only use the provided
Infrared Blaster included with the ALIEN HUNTER to charge the lithium polymer battery installed in the ALIEN HUNTER.
FCC NOTE: U.S. ONLY
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These Limits are designed to provide reasonable protection against harmful interference
in a residential installation. This generates, uses and can radiate radio frequency energy and if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the
following measures: - Reorient or relocate the receiving antenna - Increase the separation between the equipment and receiver Connect the equipment to an outlet on a circuit different from that to which the receiver is connected - Consult the dealer or an
experienced radio/TV technician for help.
Limited 30-day warranty
Product is warranted by Interactive Toy Concepts Limited against manufacturing defects in material
and workmanship under normal use for (30) days from the date of purchase.
Warranty is validated upon receipt of proof or purchase
and confirmation of UPC code.
Alien Hunter is a registered trademarks of Interactive Toy Concepts.
© 2009. All Rights Reserved. Manufactured by and distributed by InteractiveToy Concepts Ltd.
Patent Information: EU: EP1958681 US: US2008191100 Canada: CA2607358 Aus: AU2007231617
Products and colors may vary. MADE IN CHINA.
Proof of Purchase
INS-44054-100208 -US
INSTRUCTION
INSTRUCTION MANUAL
MANUAL
Congratulations on
your purchase of the
ALIEN HUNTER
The ALIEN HUNTER is a revolutionary new toy that
allows anyone to have the virtual experience of hunting
an Alien in complete safety.
The ALIEN HUNTER Blaster uses a narrow infrared beam to shoot down a fully
functional, flying “ornithopter” Alien. An ornithopter is a device that flies by flapping
its wings. Thus, the ornithopter Alien’s flying pattern is very life-like. The Alien will fly
for 30-40 seconds from a 10 second charge. The body of the Alien is made of an
ultra-light and flexible foam which provides excellent structure and resistance to
damage. Since the flying direction of the Alien can be preset, it is possible to play
with the ifly ALIEN HUNTER indoors or outdoors. It takes 3 direct hits from the
infrared Blaster to bring down the Alien. It is possible to have a competitive
game-play with any number of multiple players or to practice solo target shooting
accuracy.
A multiple player game-play consists of counting the number of shots fired to bring
down the Alien. The person who fires the least amount of shots is the winner.
The ALIEN HUNTER
has been carefully
packaged to avoid
damage during
shipping.
PLEASE USE
CAUTION WHEN
UNPACKING.
1 “ALIEN HUNTER” Flying Alien
IMPORTANT BATTERY INFORMATION:
Do not mix old and new batteries, different types of batteries, standard carbon zinc, alkaline or rechargeable of
different capacities. Rechargeable batteries are only to be charged under adult supervision. Please respect the
correct polarity (-) or (+). Do not try to recharge non-rechargeable batteries. Do not throw batteries into the fire.
Replace all batteries of the same type/brand at the same time. The supply terminals are not to be short-circuited.
Remove exhausted batteries from the toy. Batteries should be replaced by adults. Remove batteries if the toy is
not going to be played with for some time. The packaging should be kept since it contains important information.
1 Charger/
Display Stand
1 Infrared
Blaster/Portable
Charger
INSTALLING BATTERIES
The Alien has a built-in, non-removable, non-replaceable, rechargeable capacitor. The charger is built into the Infrared Blaster and
requires 3 “AAA” alkaline batteries (sold separately). Use only the supplied charger provided in this ALIEN HUNTER package to charge
the Alien. DO NOT USE ANY OTHER SOURCE TO CHARGE THE ALIEN. Install the batteries as shown.
1. Open the battery compartment door
located at the left side of the Infrared
Blaster by using a Philips screwdriver
(not included).
2. Insert the 3 AAA batteries according to
the picture (shown). Ensure that the +
and – polarities match the illustrations
inside the battery compartment.
3. Replace the battery compartment door
and tighten the screw using the
screwdriver. Do not over tighten.
CHARGING THE ALIEN HUNTER
The Alien requires 10 seconds of charging time for a flight-time of 30 to 40 seconds. Charging the Alien is a simple process as
outlined in the following steps.
CHOOSING YOUR FLYING LOCATION
Do not fly your Alien during windy conditions or harsh weather.
You can operate your ALIEN HUNTER toy indoors or outdoors.
The outdoor space should be roughly 32’ x 32’ (10m x 10m) with
a height allowance of about 19’ (6m). Avoid operating your
FLYING AND HUNTING YOUR ALIEN HUNTER
The Alien is ready to fly as soon as it is finished charging. The
objective of the iFly ALIEN HUNTER game using single or
multiple player mode is to shoot down the Alien with the Infrared
Blaster within its 30 to 40 second flight time window. It takes 3
direct hits to bring down the Alien.
1. When you are ready to fly your fully charged Alien you
should first adjust the “direction of flight” setting to the fly pattern
of your choice. This is done by pivoting the directional control
tab to the left, center, or to the right. The directional control tab
is located at the dorsal (upper) rear end of the Alien’s body and
has the two main wings attached to it. By pivoting the directional
control tab to the left, the Alien will fly to the left and by pivoting
the directional control tab to the right, the Alien will fly to the
right. When the directional control tab is positioned in the
center, the Alien will fly straight. The farther the directional
control tab is pivoted towards a certain side, the more the Alien
will bank towards that direction during its flight.
ALIEN HUNTER near power-lines, trees, or roof-tops. If flying
your Alien indoors, the area should be roughly 16’ x 16’ (5m x
5m) and the standard household ceiling height.
DIRECTIONAL
CONTROL TAB
DIRECTIONAL
CONTROL TAB
ON
OFF
OFF
1. Turn the Alien’s ON/OFF switch to the
OFF position for charging.
ON
OFF
2. Turn the Infrared Blaster’s ON/OFF
switch to the ON position for charging.
ON
3. Lift the charge-rod located at the top
front of the Infrared Blaster to the up position.
LEC Light
SNAP
DOWN
FIRMLY
The red LED charge light located in the On/Off
switch on the top of the Blaster near the
charge rod will light up during charging.
4. Locate the charge hole on the bottom
side of the Alien and insert the Infrared
Blaster’s charge rod completely. The Alien
will sit on the Infrared Blaster securely.
WARNING! DO NOT CHARGE FOR LONGER THAN 10 SECONDS. DAMAGE MAY OCCUR TO THE CAPACITOR INSIDE THE ALIEN HUNTER.
7. The Alien is now ready to fly. The
charge is maintained until the ON/OFF
switch on the Alien is set to the ON
position. This handy feature allows you to
fly your Alien when YOU are ready!
5. Press and hold the charge button
located in the trigger area of the Infrared
Blaster for about 10 seconds.
8. Leave the Infrared Blaster’s ON/OFF switch in the ON
position after charging the Alien. Press the charge rod
down on the Infrared Blaster after charging. In the down
position, the notch on the charge rod can be used for target
sighting.
6. Release the charge button after 10 seconds
of charging the Alien. The red LED charge
light will turn off. Remove the Alien from the
charge rod on the Infrared Blaster.
ON
OFF
OFF
2. Move the Alien’s ON/OFF
switch to the ON position.
The wings will start to flap.
ON
3. Gently toss the Alien into
the air. It will fly for about 30
to 40 seconds.
4. To fire at the Alien, it is necessary to reload the Infrared
Blaster. Reloading the Infrared Blaster is done by sliding the
pump all the way backwards and forwards. A reloading sound is
heard if this process is done successfully. Note: it is necessary
to reload the Infrared Blaster after each shot fired. Once the
Blaster is reloaded, you can fire a narrow infrared beam at the
Alien by pressing the trigger button on the Shooter. A firing
sound is heard.
• When charging, make sure to firmly snap down alien onto charge pod
• If your shot misses the Alien, the Alien will continue to fly in it’s pre-determined path.
• If your shot hits the Alien, it will stop operating for a brief moment and appear to fall. This is meant to
simulate a glancing blow to the Alien. The Alien will resume its flight right away.
• Reload the Infrared Blaster and shoot at the Alien again.
• When you shoot the Alien directly for the second time, the Alien will appear to temporarily fall again.
Normal flight will resume again momentarily.
• Reload the Infrared Blaster and shoot at the Alien again.
• When you shoot the Alien directly for the third time, it will fall from the sky.
Congratulations on your marksmanship!
• If you are unable to hit the Alien three times with the narrow infrared beam of your Infrared Blaster the
Alien will land on the ground naturally.
5. When the Alien has been shot down or has landed on its own,
turn it OFF to recharge it before playing again. Turning the Alien
OFF resets the system. It is not necessary to turn the Infrared
Blaster OFF before recharging the Alien. To recharge the Alien,
follow the steps outlined under “Charging the ALIEN HUNTER”.
6. If you are finished playing, make sure to turn the ON/OFF
switches on the Alien and on the Infrared Blaster to the OFF
position for storing. It is best to remove the batteries from the
Infrared Blaster if it will be stored for a longer period of time.
Loading...