Intellitrac
IT-123
Device ID:-_______________________
Device PIN:-___________
IntelliTrac
11 Scholar Drive
Bundoora, 3083
Victoria Australia
Phone (03) 9467 6188 or 1300 767 492
www.intellitrac.com.au
Hardware Quick Installation Guide
1.
Introduction
Front Panel: Rear Panel:
Power Connector Function Key
2.
Insert the SIM Card
Please follow the steps below to insert the SIM Card correctly.
a. Ensure the Sim Card is NOT pin locked
b. Unscrew the back cover of device and pull out the lid by sliding lock to the right.
c. Lift up the battery (if the battery is connected to the device)
d. Unlock the SIM card slot by sliding the holder toward the “OPEN” direction.
e. Place the SIM card into the SIM card holder.
f. Lock the SIM card slot by sliding the holder toward the “LOCK” direction.
g. Then, put back the battery and screw the back cover of the device.
Please ensure the SIM card is well placed in the holder and
well contacted; otherwise, the device might not detect
the SIM card successfully.
3. Insert the backup battery
Please follow the steps below to insert the backup battery correctly.
a. Unscrew the back cover of device and pull out the lid by sliding lock to the right.
b. Connect the cable to the socket in the corner and place the battery .
c. Then, put the cover of the device back and screw it in.
4. Installing IT-123 into a Motor Vehicle
4.1 Power/Input Cable:
Make the Electrical Connections first.
Check your connections prior to plugging in the device.
The pin assignment is following:
Pin Assignment:
Pin Definition
Cable Colour Description
1
Power Red
Connect to a Constant 12v source in
the vehicle
2
Ground Black
Connect to the vehicle body or an
electrical earth point
3
Input 1 White
Connect to an Ignition Source : This
is a 12 volt power source when the
Vehicle is running and switches to
ground or 0 volt when the vehicle is
turned off.
GPS and GSM Antennas must be connected to the relevant connectors (See Front Panel). The GPS
and GSM antennas must be installed at least 60 cm apart. The GPS antenna must be mounted so
that the black plastic face has a clear view of the sky and is not obstructed by metallic objects.
GSM Antenna
GPS Antenna
5. Mounting the IT-123
Please refer to the following:
a. Please inlet the holding metal bars to the two sides of the device body.
b. Then, screw the metal bars onto a flat place.
6. LED Indicators
Indicators
Blinking Behaviour Status
GSM
(RED)
0.6 second on/ 0.6 second off Not Ready or Searching GSM signal
0.1 second on / 3 seconds off Registered to GSM network successfully
GPS
(GREEN)
Extinguish GPS off
1 second on / 1 seconds off GPS not fixed
Solid on GPS fixed
7. Programming The IT-123
Note:- All mobile phones accessing the IT123 must have Caller ID enabled.
Step 1:- Setup the Master Phone Number.
This defines the phone number that will program the device and receive all confirmation messages.
SMS the following command to the phone number in the IT-123.
$WP+commtype=PIN,1,Master Phone
Where:-
PIN is the allocated pin of the device as defined on the front page of this manual.
Master Phone is the phone number of the phone you are using to send this sms.
Example:-
$WP+commtype=0000,1,0412345678
The IT-123 will send a return confirmation SMS to your master phone number as
follows:-
$OK:COMMTYPE=1,0412345678,,,,,0.0.0.0,0,0,0.0.0.0
Step 2:- Setup the IT-123 Time Zone.
This defines the time zone of the IT123. If you do not set this command, the IT-123 will report all
positions using GMT Time (London Time).
SMS the following command to the phone number in the IT-123.
$WP+SETTZ=PIN,+/-,hour, minute
Where:-
PIN is the allocated pin of the device as defined on the front page of this manual.
Example:-
$WP+SETTZ=0000,+,10,00
The IT-123 will send a return confirmation SMS to your master phone number as
follows:-
$OK:SETTZ=+,10,0
Times Zones for Australia.
Eastern Seaboard +,10,00 or +,11,00 for Daylight Savings Time
SA +,09,30 or +,10,30 for Daylight Saving Time
WA +,08,00 ot +,09,00 for Daylight Savings Time
Step 3:- Setup the IT-123 VIP Numbers.
This defines ALL the telephone numbers that are able to query the location of the IT123. Up to 5
numbers may be defined
SMS the following command to the phone number in the IT-123.
$WP+SETVIP=PIN,SMS1,SMS2,SMS3,SMS4,SMS5
Where:-
PIN is the allocated pin of the device as defined on the front page of this manual.
SMS1 to SMS5 define the 5 telephone numbers that the device will accept incoming calls from to
return an SMS defining location.
Example:-
$WP+SETVIP=0000,0412345678,0400123456,04011253456,,
Or $WP+SETVIP=0000,0412345678,0400123456,,, (if only 2 numbers)
Or $WP+SETVIP=0000,0412345678,,,, (if only 1 number)
The IT-123 will send a return confirmation SMS to your master phone number as
follows:-
$OK:SETVIP=0412345678,0400123456,04011253456,,
Step 4:- Setup the IT-123 VIP Number Selection.
This defines the telephone numbers that you can easily select or change from those defined in step 3.
SMS the following command to the phone number in the IT-123.
$WP+VPOS=PIN,2,Selection
Where:-
PIN is the allocated pin of the device as defined on the front page of this manual.
Example:-
$WP+VPOS=0000,2,1
Selects only 1st number defined above 0412345678
$WP+VPOS=0000,2,2
Selects only 2nd number defined above 0400123456
$WP+VPOS=0000,2,5
Selects 3rd and 1st number defined above 0412345678, 04011253456
The IT-123 will send a return confirmation SMS to your master phone number as
follows:-
$OK:VPOS=2,1
Selection Mask Value
1 Selects SMS1
2 Selects SMS2
4 Selects SMS3
8 Selects SMS4
16 Selects SMS5
Example: To select SMS1 = 1
To select SMS1,SMS2 =1+2=3
To select SMS1, SMS2, SMS3 = 1+2+4 = 7
To select SMS1,SMS2,SMS3,SMS4 = 1+2+4+8=15
To select SMS1,SMS2,SMS3,SMS4,SMS5=1+2+4+8+16=31
8. Tracking The IT-123
Step 1:- Dial the phone number of the sim card inside the IT123
Note:- Your Caller ID must be ON
The SIM Card in the device must also have caller ID activated by
the mobile phone carrier
Step 2:- If the IT-123 recognises your number as a programmed VIP number it will
answer the call after 2-3 rings and immediately hang up.
Step 3:- The IT-123 will send a location SMS to all VIP SMS Phones
When you receive the SMS, simply click on the Google link and a Google
map will open showing the location of the IT-123.
Dial Receive SMS
Click on Link
View Map on Phone
Loading...