Intellisystem IT750, IT750W, IT750W-LR Quick Installation Manual
Intellisystem Technologies S.r.l. http://www.intellisystem.it
IT750/IT750W/IT750W-LR
Network Camera with Pan/Tilt/Zoom
Quick Installation Guide
This guide describes the basic functions of
IT750/IT750W/IT750W-LR Network Camera.
All detailed information is described in the
user's manual.
Warning Before Install
1
Intellisystem Technologies S.r.l. http://www.intellisystem.it
IT750/IT750W/IT750W-LR Quick Start Guide
2
Intellisystem Technologies S.r.l. http://www.intellisystem.it
IT750/IT750W/IT750W-LR Quick Start Guide
IT750 Aluminium Housing Assembling
Components: Step 1: Get the power wire through the
bracket first.
Step 5: Finally cover up, and the
assembling is accomplished.
Step 2: Then through out from the housing
part, meanwhile insert the power cable
to the appropriate socket. (P.S. This device
is suitable for AC or DC input, no negative
or positive discriminate)
Step 4: Screw on the two side screws, and
plug in the power of the dome.
(1) Bracket
(2) Cover
(3) Housing
(5) Dome
(5) Remote controller
(4) Power
Screw on
Screw on
Step 3: Screw the dome on the
fixing bridge.
3
Intellisystem Technologies S.r.l. http://www.intellisystem.it
IT750/IT750W/IT750W-LR Quick Start Guide
IT750W Aluminium Housing Assembling
Components: Step 1: Get the power wire through the
bracket first.
Step 5: Finally cover up, and the
assembling is accomplished.
Step 2: Then through out from the housing
part, meanwhile insert the power cable
to appropriate socket. (P.S. This device
is suitable for AC or DC input, no negative
or positive discriminate)
Step 4: Screw on the two side screws, and
plug in the power of the dome.
(1) Bracket
(2) Cover
(3) Housing
(5) Dome
(4) Power
(6) Antennas
Screw on
Screw on
Step 3: Screw the dome on the
fixing bridge.
(5) Remote
controller
4
Intellisystem Technologies S.r.l. http://www.intellisystem.it
IT750/IT750W/IT750W-LR Quick Start Guide
IT750W-LR Aluminium Housing Assembling
Components: Step 1: Get the power wire through the
bracket first.
Step 5: Finally cover up, and the
assembling is accomplished.
Step 2: Then through out from the housing
part, meanwhile insert the power cable
to the appropriate socket. (P.S. This device
is suitable for AC or DC input, no negative
or positive discriminate)
Step 4: Screw on the two side screws, and
plug in the power of the dome.
(1) Bracket
(2) Cover
(3) Housing
(5) Dome
(4) Power
(6) Antennas
Screw on
Screw on
Step 3: : Pass the cables of two antennas
through the holes in the bracket
screw on the antennas.
housing part into the
Attention to the cables inside!
and
Screw
bracket.
(5) Remote
controller
Loading...