Page 1
WALL
MOUNT
PATCH PANEL
QUICK
START
GUIDE
12-port
Cat5e
UTP
model
shown
Thank you for purchasing this INTELLINET NETWORK SOLUTIONS™ Wall Mount
Patch Panel.
Follow the steps on this quick start guide for easy installation and use of either the
Cat5e or Cat6 version of this product.
IDC (3 options)
110D
type
approx. 30 mm
Krone
type
wire holder
1. Carefully strip away approximately 30 mm of the cable jacket(s) (above
left) to be connected to the Patch Panel, separating the wires into four
pairs. Using a wire cutter, cut the wire holder (above right) flush with the
cable jacket.
110D & Krone
IDC compatible
T568A
IN 5 WHITE/BLUE
P
PIN 4 BLUE
PIN 1 WHITE/GREEN
PIN 2 GREEN
PIN 3 WHITE/ORANGE
PIN 6 ORANGE
PIN 7 WHITE/BROWN
PIN 8 BROWN
T568B
IN 5 WHITE/BLUE
P
PIN 4 BLUE
PIN 1 WHITE/ORANGE
PIN 2 ORANGE
PIN 3 WHITE/GREEN
PIN 6 GREEN
PIN 7 WHITE/BROWN
PIN 8 BROWN
2. Follow the IDC
color-code chart
above to position
the wires, then use
a Krone punch down tool to crimp
and connect them.
www.intellinet-network.com
Are you completely satisfied with this product?
INTELLINET NETWORK SOLUTIONS
All products mentioned are trademarks or registered trademark s
Please contact your
dealer with comments or questions.
Copyright © INTEL LINET NE TWORK
of their respective own ers.
™
SOLUTIO NS
INT-PPWM-QSG-1206-02
Loading...