Intellinet 550857 Quick Install Manual

NSC18-WN
Pa N / TilT
NeTWork
Camera

quiCk
iNSTall
guide

MODEL
550857

INT-550857-QIG-0709-01

3

iNTroduCTioN

Thank you for purchasing the INTELLINET NETWORK SOLUTIONS™
NSC18-WN Pan/Tilt Network Camera, Model 550857.

This quick install guide presents the rudimentary steps required to set
up and operate this device. For software installation procedures, detailed

instructions and specications, refer to the user manual 1) on the CD
enclosed with this product; 2) on the Web site listed below; or 3) in some

cases, printed and enclosed with this product. Contact your INTELLINET
NETWORK SOLUTIONS dealer with comments or questions, or visit
www.intellinet-network.com for information on the latest software and

rmware updates, related products and additional contact information.
Some screen images have been modied to t the format of this guide.

System Requirements

• Windows 2000, XP, Vista

• Computer with network connection

• Web browser support: MS Internet Explorer 6.0 or higher (ActiveX)

Package Contents

• NSC18-WN Pan/Tilt Network Camera

• 2 detachable antennas

• Power adapter

• Quick installation guide

• Software CD with user manual

• Ethernet Cat5 RJ45 cable: 1.0 m (3 ft.)

NOTE: Video and audio surveillance can be forbidden by laws that vary
from country to country. Check the laws where you install this device

before using it for surveillance purposes.

3

4

4

regulaTory STaTemeNTS

EU Declaration of Conformity
This device complies with the essential requirements of the R&TTE

Directive 1999/5/EC. This device is a 2.4 GHz wideband transmission
system (transceiver) intended for use in all EU member states and EFTA
countries, except in France and Italy, where restrictive use applies.

In Italy, the end-user should apply for a license at the national spectrum

authorities in order to obtain authorization to use the device for setting up
outdoor radio links and/or for supplying public access to telecommunications

and/or network services.

This device may not be used for setting up outdoor radio links in France,
and in some areas the RF output power may be limited to 10 mW EIRP
in the frequency range of 2454 – 2483.5 MHz. For detailed information,

the end-user should contact the national spectrum authority in France.

Federal Communications Commission Interference Statement
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause

harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: 1) This device may not cause harmful

interference, and 2) This device must accept any interference received,

including interference that may cause undesired operation.
FCC Caution

Any changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate

this equipment.
IEEE 802.11b or 802.11g operation of this product in the U.S. is rmware-
limited to channels 1 through 11.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 20 cm (approximately 8 in.) between
the radiator and your body. This transmitter must not be co-located or
operated in conjunction with any other antenna or transmitter.

SafeTy PreCauTioNS

This product has been designed with safety in mind, but as electrical
products can cause res which may lead to serious damage and injury
if not used properly, observe these precautions:

• Don’t open the camera housing or otherwise expose yourself to
dangerous voltage or other hazards inside.

• Don’t attach/connect accessories that aren’t designed for this device.

• Avoid operating or storing the camera in extreme temperatures (see
Specications in the user manual).

• Avoid exposing the camera to direct sunlight for a long time.

• Don’t place the camera near heat sources.

• Don’t place the camera near water (e.g., next to a bathtub or sink) or
in an extremely hot or humid environment.

• Don’t place the camera near sources of strong magnetism.

• Don’t place the camera near sources of powerful electromagnetic
radiation, such as radios or TV transmitters.

• Don’t place the camera in locations subject to strong vibration or

shock.

5