Intellinet 524803 Quick Install Guide

WIRELESS
150N
PORTABLE
3G ROUTER

QUICK
INSTALL
GUIDE

MODEL 524803

INT-524803-QIG-1009-02

Thank you for purchasing the INTELLINET NETWORK SOLUTIONS™
Wireless 150N Portable 3G Router, Model 524803.

This quick install guide presents the basic steps required to set up and
operate this device. For detailed instructions and specications, refer to
the user manual on the enclosed CD or at www.intellinet-network.com.
Easy-to-follow instructions in this guide and the user manual help make
installation of the switch quick and simple, so you’ll soon be enjoying the

benets of these features:

• Supports UMTS/HSDPA and EVDO 3G networks

• Up to 150 Mbps network link speed

• Complies with 2.4 GHz Draft IEEE 802.11n standard and is
backward compatible with IEEE 802.11g/b standards

• Supports WMM to meet the multimedia data bandwidth requirements

• Supports Wi-Fi Protected Setup (WPS)

• Supports WAN connection auto fail-over

• Supports WEP and WPA/WPA2 (TKIP and AES) data encryption

• DHCP server supports static lease management

• Supports virtual server, port forwarding and DMZ (demilitarized zone)

• Supports DDNS (dynamic DNS)

• Supports UPnP (Universal Plug and Play)

• Integrated anti-DOS rewall

• QoS (Quality of Service) bandwidth management

• VPN Passthrough (PPTP/IPSec)

• Integrated USB 2.0 port for UMTS/HSDPA and EVDO 3G modems

• Easy installation through Web-based user interface

• Lifetime Warranty

Package Contents

• Wireless 150N Portable 3G Router

• Quick install guide, plus user manual on CD

• Power adapter

• Built-in rechargable Li-ion battery

• Ethernet Cat5 RJ45 cable: 1.0 m (3 ft.)

• USB extension cable: 1.0 m (3 ft.)

• Carrying case and car charger

2

REGULATORY STATEMENTS

Federal Communications Commission (FCC)

FCC Part 15
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.

2. Increase the separation between the equipment and receiver.

3. Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.

4. Consult the dealer or an experienced radio technician for help.
FCC Caution

This equipment must be installed and operated in accordance with provided
instructions, and a minimum 20 cm spacing must be provided between

computer mounted antenna and person’s body (excluding extremities of
hands, wrists and feet) during wireless modes of operation.

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: 1) This device may not cause harmful
interference; and 2) This device must accept any interference received,

including interference that may cause undesired operation.

Any changes or modications not expressly approved by the party

responsible for compliance could void the authority to operate equipment.
FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure set forth for an
uncontrolled environment. In order to avoid the possibility of exceeding

3

the FCC radio frequency exposure limits, human proximity to the antenna
shall not be less than 20 cm (8 inches) during normal operation.
The antenna(s) used for this transmitter must not be co-located or

operating in conjunction with any other antenna or transmitter.
The equipment marketed in the U.S. is restricted to usage of channels 1-11.

R&TTE Compliance Statement

This equipment complies with all the requirements of Directive 1999/5/

EC of the European Parliament and the Council of March 9, 1999, on
radio equipment and telecommunication terminal Equipment and the

mutual recognition of their conformity (R&TTE).
The R&TTE Directive repeals and replaces in the directive 98/13/EEC
(Telecommunications Terminal Equipment and Satellite Earth Station
Equipment) as of April 8, 2000.

Safety
This equipment is designed with the utmost care for the safety of those
who install and use it. However, special attention must be paid to the
dangers of electric shock and static electricity when working with electrical
equipment. All guidelines of this and of the computer manufacture must
therefore be allowed at all times to ensure the safe use of the equipment.

EU Countries Intended for Use

The ETSI version of this device is intended for home and ofce use in
Austria, Belgium, Denmark, Finland, France, Germany, Greece, Ireland,
Italy, Luxembourg, the Netherlands, Portugal, Spain, Sweden, and the

United Kingdom.

The ETSI version of this device is also authorized for use in EFTA member
states: Iceland, Liechtenstein, Norway, and Switzerland

EU Countries Not Intended for Use
None.

4