Intellinet 524063, 524087 User Manual

GiGabit
EthErnEt
rackmount
WEb-Smart
SWitch

uSEr
manual

MODELS 524063
& 524087

INT-524063/524087-UM-0308-01

Model shown: 524063, 24-port

introduction

Thank you for purchasing the INTELLINET NETWORK SOLUTIONS™
Gigabit Ethernet Rackmount Web-Smart Switch, Model 524063 (24-port)
or Model 524087 (16-port).

This handy device lets you increase the speed of your network with
10/100/1000 Mbps auto-sensing ports that automatically detect optimal
network speeds, and it lets you increase the speed of your own work
through user-friendly Web-based management for uncomplicated
administration.

Easy-to-follow instructions in this user manual help make installation of
the switch quick and simple, so you’ll also soon be enjoying the benets
of these additional features:

• All RJ-45 ports with Auto-MDIX (auto uplink) support

• Supports NWay auto-negotiation

• Broadcast storm control with multicast packet rate settings

• Store and forward switching architecture

• Full/half duplex operation

• IEEE 802.3x ow control for full duplex

• Zero packet loss backpressure ow control for half duplex

• Packet ltering/forwarding rates: 1,488,000 pps (1000 Mbps), 148,800 pps

(100 Mbps), 14,880 pps (10 Mbps)

• Supports port controls (speed, ow control and maximum frame size)

• Supports VLAN (tag-based and port-based)

• Supports link aggregation (trunking)

• Supports QoS (Quality of Service) with 2 priority levels

• Provides IEEE 802.1x port-based security

• Supports port mirroring

• Supports jumbo frames up to 9.6 kBytes

• 19” rackmount

• LEDs for power, link/activity, connection speed

• Lifetime Warranty

NOTE: Some screen images have been modied to t the manual format.

3

SEtup

• Using twisted-pair cable, connect the switch to your computer.

• Using the included power cord, connect the Gigabit Ethernet
Rackmount Web-Smart Switch to an AC power source.

confiGuration

1. Set your PC’s
IP address to

192.168.2.xxx
(where “xxx”
is a value from
2 to 254).

2. Open the Web
browser; go to

192.168.2.1 to
display the
conguration
login screen.

4

LED Status Operation

POWER On There is power to the unit.
1000M On The corresponding port is transmitting/receiving at 1000 Mbps.
Off The corresponding port is transmitting/receiving at 10/100 Mbps.
LINK/ACT On The corresponding port is connected to another device.

3. Enter “admin” in the
Password eld, then
click “Apply.” The
authentication process
will now allow you to
navigate among/within

the primary menu options: Conguration, Monitoring and Maintenance.

Conguration

System

This screen presents the
MAC address, system

rmware version and

several other settings/
readings. You can change
the user name, password
and IP address, then click

“Apply” to conrm any

changes. After that, you
can reset the switch to
make the new username,
password or IP address
take effect.

5