Intellinet 523790, 523806 User Manual

16/24 PORT
FAST
ETHERNET
WEB-SMART
SWITCH

USER
MANUAL

MODELS 523790 & 523806

INT-523790/523806-UM-0407-02

INTRODUCTION

Thank you for purchasing the INTELLINET NETWORK SOLUTIONS™ 16-Port (Model 523790)
or 24-Port (Model 523806) Fast Ethernet Web-Smart Switch.

This device is designed for growing businesses that want control over their network without the
cost and complexity of a full Layer 2/Layer 3 management implementation. This high-performing
switch features a non-blocking wire-speed architecture for maximum data throughput. All
RJ-45 ports automatically negotiate to the highest speed and support Auto Uplink technology
to make the right link. In addition, an intuitive, Web-browser interface offers the simple Smart
Switch management, making it a snap to monitor switch performance, congure ports, even

set up port trunks, VLANs and trafc prioritization.

Shipped ready for use straight out of the box, INTELLINET NETWORK SOLUTIONS Web­Smart Switches are ideal for adding basic management to your unmanaged networks and
extending your managed networks. The easy-to-follow instructions in this user manual help

make setup and operation quick and simple, so you’ll also soon be enjoying the benets of

these additional features:

• 10/100 Mbps auto-sensing Auto-MDIX RJ-45 ports automatically detecting optimal network
speeds

• Conguration via Web browser

• Supports NWay auto-negotiation

• Store and forward switching architecture

• Full/half duplex operation

• IEEE 802.3x ow control for full duplex

• Zero packet loss back-pressure ow control for half duplex

• Packet ltering/forwarding rates: 148,800 pps (100 Mbps), 14,880 pps (10 Mbps)

• Supports port-based VLAN, 8 groups

• Supports three types of QoS: port-based, 802.1p and DiffServ

• Supports Spanning Tree protocol

• Bandwidth control for all ports with 8 levels

• Broadcast storm control

• Supports MAC address port security

• Supports user-dened maximum forwarding packet size (1536 or 1552)

• Supports up to 4096 MAC address entries

• 192 kBytes buffer memory

• Lifetime Warranty

FCC Warning

This device has been tested and found to comply with limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses and radiates radio frequency energy and, if not
installed and used in accordance with the user’s manual, may cause interference, in which
case the user will be required to correct the interference at his own expense.

CE Mark Warning

This is a Class A product. In a domestic environment, this product may cause radio
interference, in which case the user may be required to take adequate measures.

3

INTRO DUCTION

SETUP/INSTALLATION

Front Panel

The RJ-45 connectors on the front panel of the Fast Ethernet Web-Smart Switch (16 for
Model 523790, shown below; 24 for Model 523806, with a similar layout) are for connecting to
servers, workstations or other network components. The device features a corresponding
number of 10/100 Mbps switching ports that sense the speed and automatically negotiate full/
half duplex mode, allowing you make both 10Base-T and 100Base-TX connections.

The image at right is an example of how a network can be
congured using the Fast Ethernet Web-Smart Switch in
combination with servers, individual workstations and
other devices.

Additionally, any port on the Fast Ethernet
Web-Smart Switch can serve as an uplink port
connected with another hub or switch in order to
expand and share the same function, as shown
in the image below.

Rear Panel

The On/Off switch and the AC connection are located on the rear
panel of the Fast Ethernet Web-Smart Switch, as shown at right.

4

SETUP/INSTALL ATION

Model 523790

2 4 6 8 10 12 14 16

1 3 5 7 9 11 13 15

LED Status Function/Activity

POWER On (green) Power is available to the switch.
10/100M On (green) The corresponding port is operating at 100 Mbps.
Off The corresponding port is operating at 10 Mbps.
LINK/ACT On (green) The corresponding port is ready for connection/operation.
Flashing (green) The corresponding port is transmitting data.