Intellinet 523646, 523653 User Manual

INT-523646/523653-UM-0107-03

5/8-PORT
FAST ETHERNET
OFFICE SWITCH

USER MANUAL

MODEL 523646/523653

2

Thank you for purchasing the INTELLINET NETWORK SOLUTIONS™ Fast Ethernet Office
Switch, Model 523646 (5-port) or Model 523653 (8-port).

Use this manual for reference when setting up and operating this switch, and enjoy the benefits
of high-speed dynamic memory, which supports the packet store-and-forward architecture;
IEEE802.3x back-pressure flow control, which manages the data flow between sending and
receiving nodes to prevent packet loss; and these additional popular features:

• 10/100 auto-sensing ports automatically detect optimal network speeds

• Supports any combination of 10 Mbps or 100 Mbps network devices

• All RJ-45 ports with Auto-MDIX and NWay auto-negotiation support

• Compact case makes positioning easy

• 10/100 Mbps and half/full duplex

• NWay Auto-Negotiation

• Non-blocking design

• Supports Broadcast Storm control

• LEDs for power, link/activity

• Supports 1024 MAC address entries

• 128 kBytes buffer memory (5-port); 256 kBytes buffer memory (8-port)

• Lifetime Warranty

3

FRONT PANEL

The front-panel LED indicators — POWER, LINK/ACT — allow for more convenient monitoring
and troubleshooting of the switch. The table below shows each LED function.

REAR PANEL

Power receptacle: Plug the female end of the power cord firmly into the receptacle and the
other end into an electrical outlet. Confirm that the power LED is lit for a normal power status.
NOTE: To ensure proper operation, use only the power cord included with the switch.

Ports: All the ports on the Fast Ethernet Office Switch support Auto-MDI/MDI-X functionality, so
crossover cables and uplink ports are not needed for connections to PCs, routers, hubs,
additional switches or other devices. Cat5/5e UTP/STP cables provide optimal performance;
if a front-panel LED corresponding to any of the ports in use doesn’t indicate a link or activity,
check the connected device for proper setup and operation.

System LED Status Operation

POWER Steady green Power on
Off Check AC connection; turn on power switch

LINK/ACT Steady green Valid port connection
Blinking green Valid port connection; data being transmitted/received