Intellinet 505093 User Manual

FAST ETHERNET
RACKMOUNT
WEB-SMART
SWITCH

INT-505093-UM-0906-01

WITH OPTIONAL GIGABIT PORTS

USER MANUAL

MODEL 505093

22

TABLE OF CONTENTS

1. Introduction & Features ....................................................3

2. Hardware Installation ......................................................3

3. Software Settings .............................................................4

4. Functions & Configurations ..............................................6

Port Status ..............................................................................6

Port Configuration ....................................................................6

Trunk Configuration ..................................................................6

VLAN Configuration .................................................................7

Port Monitoring Configuration ....................................................7

QoS Configuration ..................................................................8

Bandwidth Control ..................................................................8

Miscellaneous Operations .........................................................8

5. Web Login .........................................................................9

Setting an IP Address with the Web-Smart Switch .........................9

Logging In with a Web Browser .................................................9

6. Specifications ..................................................................10

section page

TABLE OF CONTENTS

3

1. INTRODUCTION & FEATURES

Thank you for your purchase of the INTELLINET NETWORK SOLUTIONS™
Fast Ethernet Rackmount Web-Smart Switch with Optional Gigabit Ports,
Model 505093. Following is an introductory overview of the Web-Smart
Switch features.

• Supports real-time status read/write operation.

• Provides online link status.

• Supports port setting for NWay or force-mode operation.

• One port-based trunk supports speeds up to 800 Mbps.

• Supports load balancing on the trunking port.

• Optional fiber-optic module for 100Base-FX application.

2. HARDWARE INSTALLATION

Accessories

• One null modem cable

• One D-sub 9-pin female connector on front panel

• Fiber module (optional) multimodule/single module (ST- or SC-type connector)
Turn off the power to

your PC and Fast Ethernet
Rackmount Web-Smart
Switch, then connect the
null modem cable to the PC
serial port and the Smart
Switch D-sub connector.

NOTE: When you connect
the cable, remember which
serial port you used. (Refer
to Step 3 of Section 3.)

3

INTRODUCTION / HARDWARE INSTALLATION

Optional Gigabit Ports
(modules not included)

4

3. SOFTWARE SETTINGS

To open the HyperTerminal program, follow the steps below.

1. Click “Start,” then “Programs,”
then “Accessories,” then
“Communications,” then
“HyperTerminal.”

2. Enter any name you care to on
the New Connection screen,
then click “OK.”

3. In the “Connect using” field,
enter the serial port where you
connected the null modem cable
to the PC.

4

SOFTWARE SETTINGS