, make sure you are operating the device in
compliance with all local, state, and federal regulations. It is the sole
responsibility of the driver of the vehicle to operate the vehicle in a safe
manner and not become distracted by the Intellinav system . You should
not operate the controls of the Intellinav system while driving, nor place
the device where it obstructs airbags operation. Netropa shall not be
liable for any accident. By using the Intellinav system, you have agreed
to the terms and agreements.
Do not mount where driver’s field of vision is blocked
Do not place on dashboard unsecured
Do not mount where airbag deployments are obstructed
Please review additional information on page 13 of this guide. For full
safety and regulatory information, please refer to the User's Manual.
Congratulations on your purchase of the
IInntteelllliinnaavv sse
from Global Positioning Satellites (GPS) orbiting the earth. Use this QuickStart Guide to start exploring your new system. When you want more
information, please refer to the User's Manual.
e
to guide you to the destination of your choice using signals
Note: If you are missing any item, please contact your
retailer.
4
Quick Start Guide
Installing the Intellinav se in your vehicle
Mounting on the Windshield
1.Clean the surface of the windshield using
rubbing alcohol.
2.Press the suction cup firmly against the
windshield.
3.Press down the lever to fix the suction cup in
place.
NOTICE TO DRIVERS IN CALIFORNIA AND MINNESOTA: State law
prohibits drivers in California (CVC 26708(a)) and Minnesota (169.71,
Minnesota Statutes 2006) from using suction mounts on their windshields
while operating motor vehicles.
Mounting on the Dashboard
1.Remove the adhesive cover on the disc, and stick the disc on the
dashboard.
2.Press the suction cup firmly against the disc.
3.Press down the lever to fix the suction cup in place.
Quick Start Guide
5
Mounting the Cradle and GPS
1. Insert the GPS unit bottom in first, and then lock it
using the lever on the top.
2.Adjust the angles of the arms to achieve the best
viewing position.
Charging the Battery
1.Prior to first use, please use the AC adapter to fully charge the unit
for 4-6 hours, until battery LED turns green.
2.In the vehicle, you may plug in the car charger to provide
continuous power. On a full charge, the unit can operate up to 5
hours.
3.To charge the battery, the Battery On/Off switch at the bottom of
the unit must in the On position.
4.To preserve battery power when the unit will not be used for an
extended period, set the Battery On/Off switch to the Off position.
6
Quick Start Guide
Loading...
+ 18 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.