INTELLI HEAT HALM-FL-LCD 4, HALM-FL-LCD 7, HALM-FL-LCD 5, HALM-FL-LCD 9, HALM-FL-LCD 11 User Manual

Roma Classic

Thermodynamic Fluid Filled

Aluminium Electric Radiator

User Manual

HALM-FL- LCD Serie

Please read this manual carefully before use

1

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic safety precautions should always be observed, including the
following:

READ ALL INSTRUCTIONS BEFORE USING
WARNING: To reduce the risk of fire, electrical shock, or injury to person:

1. The product is for household use only.

2. Connect the appliance to single-phase AC supply of the voltage specified on the rating plate.

3. In order to avoid overheating do not cover the heater.

4. Never leave the heater unattended while it is in use. Always turn the product to the OFF position and
unplug it from the electrical outlet when not in use.

5. Extreme caution is necessary when any heater is used by or near children, invalids or elderly person
and whenever the heater is left operating and unattended.

6. The heater must not be located immediately below an electrical Socket-outlet.

7. Do not run cord under carpeting and do not cover cord with throw rugs, runners or the like. Arrange
cord away from traffic area and where it will not be tripped over.

8. Do not operate the heater with a damaged cord or plug, or after the heater malfunctions, has been
dropped, or damaged in any manner.

9. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similarly
qualified person in order to avoid a hazard.

10. Avoid the use of an extension cord as this may overheat and cause a risk of fire.

11. Use the heater in a well-ventilated area. Do not insert or allow objects to enter any ventilation or
exhaust opening. To prevent a possible fire, do not block air intakes or exhaust openings in any manner.
Do not use on soft surfaces, like a bed, where openings may become blocked. Use the heater on flat, dry
surfaces only.

12. Do not place this heater near flammable materials, surfaces or substances, as there may be a risk of
fire. Keep the above flammable materials, surfaces or substances at least 1m from the front of the
product and keep them away from the sides and rear. 13. Do not use the heater in any areas where
petrol, paint or other flammable liquids are stored e.g. Garages or workshops as a hot, arcing or sparking
parts inside the heater.

14. Don’t use this heater in the immediate surroundings of a bath, a shower or a swimming pool with
floor standing mode. Never locate the heater where it may fall into bathtub or other water container.

15. Never touch the heater with wet hand. The heater should be installed so that can not be touched by a
person using a bath or shower.

16. This heater is hot when in use. To avoid burns and personal injury, do not let bare skin touch hot
surfaces.

17. Before moving the heater, please must unplugged it and let it cool down for 15 minutes. If provided,
use handles when moving the product.

18. Be sure that no other appliances are in use on the same electrical circuit as your product as an
overload can occur.

19.This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.

20.Children should be supervised to ensure that they do not play with the appliance.

21. This heater is filled with a precise quantity of special oil.

22. Repair requiring opening of the oil container are only to be made by the manufacturer or his service
agent who should be contacted if there is an oil leakage.

23. Regulations concerning the disposal of oil when scrapping the appliance have to be followed.

FOR HOUSEHOLD USE ONLY -

SAVE THESE INSTRUCTIONS

2

SPECIFICATIONS

MODEL NO

NET SIZE

RATED VOLTAGE

RATED POWER

HALM-FL-LCD 5

570X590X80mm

~230V/50Hz

900W

HALM-FL-LCD 9

890X590X80mm

~230V/50Hz

1500W

HALM-FL-LCD 4 490X590X80mm ~230V/50Hz 600W

HALM-FL-LCD 7 730X590X80mm ~230V/50Hz 1200W

HALM-FL-LCD 11 1050X590X80mm ~230V/50Hz 1800W

STRUCTURE AND PARTS

CHARACTERISTICS

1. 1 heat setting

2. Over heating protection

3. With digital LCD

4. Room temperature setting

5. Room temperature sensor

6. Digital clock, digital week calendar

7. Multi-running mode:

daily program mode, weekly program mode, free use mode

8. Anti-frost function

9. Wall-mount use

WARNING!

THIS RADIATOR IS DOUBLE INSULATED:

Being double insulated, the cable from this radiator does not carry an Earth wire, it has a Live
(brown), Neutral (grey) and a black wire, which is a pilot wire. Never connect the black Pilot Wire
to an Earth, Live or Neutral connection, if this occurs it will destroy the thermostat. The black pilot
wire is a signal wire, only to be connected to an external programmer. Please contact INTELLI
HEAT for advice on such systems. If the pilot wire is not used it must be properly insulated and
isolated to avoid accidental connection.

3

Used as wall-mounted:

HALM-FL-LCD-4

HALM-FL-LCDL-5HALM-FL-LCD-7

HALM-FL-LCD-9

HALM-FL-LCD-11

INSTALLATION

(1) Drill holes on the wall according to the picture.

Warning: Be sure to keep the distance between the heater and floor, wall and so on
accordingly.

(2) Fit the fasten tube in the holes.
(3) Fit the up-hook on the wall with screws.
(4) Hang the unit on the up-hook.
(5) Fit the bottom hook between 2 fins at the bottom of unit.
(6) Fasten he bottom hook with screw.

The distance of hanging hole is as follows:

Model

L(mm) 160 240 400 560 720

4