INTELLI HEAT anglia, cali, calidus Installation And Instructions Manual
Thermodynamic
fluid-filled radiators
INSTALLATION
Location
Installation
AND INSTRUCTIONS
CALI
CALIDUS
ANGLIA
ENG
Connection
Safety
Use
With Intelligent Thermostat
www.intelligentheat.co.uk
Thank you for choosing our product
We trust that you will be fully satisfied with the performance and quality
of your new Intelli Heat product, but to ensure your maximum comfort
and safety please ensure that you thoroughly study and understand
all the information and advice contained throughout this document.
Table of contents
PAGE 3
PAGE 4
PAGE 5
PAGE 6
PAGE 7
PAGES 8 - 9
PAGES 10 - 11
PAGE 12
PAGE 13
PAGE 14
PLEASE PAY SPECIAL ATTENTION
USER GUIDELINES
ELECTRICAL INSTALLATION GUIDELINES
INSTALLATION INSTRUCTIONS
RADIATOR WALL MOUNTING GUIDELINES
ANGLIA RADIATOR WALL MOUNTING
CALI & CALIDUS RADIATOR WALL MOUNTING
CALI, CALIDUS AND ANGLIA WEIGHTS AND SIZES
PAGE 6
PAGE 11
THERMOSTAT AND PROGRAMMER GUIDELINES
CALI RADIATOR ANALOGUE THERMOSTAT CONTROLS
PAGE 6
PAGE 15
2 3
PAGE 16
PAGE 17
CALIDUS & ANGLIA THERMOSTAT PROGRAMMING
LCD PROGRAMMER TECHNICAL CHARACTERISTICS
PROVISION FOR USER NOTES
www.intelligentheat.co.uk
All Rights on this USER GUIDE are Reserved © No reproduction is permitted - Intelli Heat and intellyGreen are patented brands
PLEASE PAY SPECIAL ATTENTION
Do not touch the radiator or thermostat when you are
wet and do not install any part of the system outdoors.
Our radiators are safe and water resistant, nevertherless we strongly advise
you not touch the radiator or thermostat with wet hands or feet, or when any
part of you is wet. This product is designed for interior use only.
CLEANING: Always ensure the radiator is turned off at the main power
source, clean with a soft, non abrasive damp cloth. Never wash with water or
allow water to go onto the thermostat or any electrical connection.
Do not cover or lay any material over the radiator.
Do not lay any material over the radiator especially if it is damp or wet. Never
place furniture or any other object against the radiator. Always ensure that
the radiator is installed in an open area to allow optimum heat to be radiated,
do not install where curtains will be drawn over the radiator.
Pay attention when children are around.
Although our radiators are designed for ease of use and safety, like with any
other electrical or heating product, always exercise caution where children
are concerned. We also strongly advise you not to allow children or any
unsuitable person to tamper with any electrical connection or to operate any
controls associated with the appliance.
PAGE 3
Never hang from the radiator or load it with weight.
Never pull, sit on, hang from or load the radiator with any weight. Such
practice may damage the radiator or cause it to come loose from the wall or
the wall fitting attachments, which could cause serious injury. Also to avoid
such injury, alway check from time to time to ensure that the radiator is
securely fixed to the wall.
Do not tamper with or modify the product.
Never attempt to alter or modify a radiator or any associated control system
or electrical connection. Such action would invalidate the warranty and may
cause system malfunction or injury. If required, our products should only be
repaired by an appropriately qualified person. Do not attempt any
maintenance or replace any damaged components. Do not apply stickers.
CAUTION - ALWAYS HANDLE HEAVY ITEMS WITH CARE.
Depending on the size and model, some radiators can be very heavy,
therefore always take every safety precaution when stroring, transporting
and installing heavy radiators. We strongly advise that at least two people lift,
move and install heavy radiators, and that each radiator is professionally and
securely fixed to the wall using the appropriate method suitable to the
construction of the wall.
All Rights on this USER GUIDE are Reserved © No reproduction is permitted - Intelli Heat and intellyGreen are patented brands
ENGLISH
PAGE 4
USER GUIDELINES
The original Thermodynamic
fluid filled radiators with Intelligent Thermostat
FOR YOUR SAFETY
IN ACCORDANCE WITH THE REGULATIONS:
The heating element inside each radiator is equiped
with an integrated fuse. In case of overloading the
fuse melts and cuts off the power supply. The heater
element must then be changed by the manufacturer
or by a qualified electrician familiar with such
products. If needed, please contact your dealer.
MAINTENANCE
To ensure the perfect functioning of you radiator and
to ensure its durability, it is necessary to clean the
radiator at least once a year. Before you start the
cleaning process you must ensure that the power
supply is turned off at the main power source.
Clean the main body of the radiator with a damp soft
cloth using, if required, a non agressive and non
abrasive cleaning product. Clean the front and side
surfaces including inbetween any groves and fins, and
where possible, the back surfaces of the radiator.
Do not use any water or cleaning products when
cleaning the thermostat, use a slightly damp soft cloth
to wipe it clean ensuring that you do not apply too
much pressure. When cleaning the thermostat hold it
with one hand as you clean it to ensure that any
connection to the radiator is not disturbed.
Never allow any water, cleaning fluid or spray cleaning
product to go onto the thermostat or any other
electrical connection.
PLEASE NOTE
FUNCTIONING
A radiator may sometimes produce light clicking
sounds, this is nothing to be concerned about. These
sounds are produced by the interlocking of certain
types of thermostats.
A radiator may also produce light cracking sounds, this
is also nothing to be concerned about. This is due to
the expansion of the various metals the radiator is
composed of. This is a natural occurence associated
with electric heaters, so it does not signal a fault.
Height
(mm)
IMPORTANT
It is essential that you keep this user guide and all
documentation related to this product for further
reference.
IF YOU SELL OR TRANSFER
Should you decide to sell or transfer this product to
a third party, this manual must also be passed to the
new owner to enable a full understanding of the
product and to ensure safety and adherence to these
guidelines. Also, should any warranty period still be in
effect, faliure to comply with this will invalidate the
warranty.
We strongly advise you to seek
expert advice if you are unsure
about any aspect of the radiator
installation process.
Waste electrical and
electronic equipment
(WEE)
Please act responsibly when disposing of any
electrical item. The WEE Directive aims to both
reduce the amount of electrical and electronic
equipment being produced and to encourage
everyone to reuse, recycle and recover it. Intelli
Heat as a manufacturer fully complies with the
UKs WEE Regulations. For further information
should you intend to dispose of an electrical
item please visit:
www.environment-agency.gov.uk.
All Rights on this USER GUIDE are Reserved © No reproduction is permitted - Intelli Heat and intellyGreen are patented brands
ELECTRICAL INSTALLATION GUIDELINES
A radiator installed in a wet room must be
connected to the electricity supply using a
standardized junction box without the use of a
PAGE 5
ESSENTIAL TARRIF INFORMATION
ECONOMY 10 (UNRESTRICTED) is reccomended to
ensure minimal running costs, Ecomony 7 is not
suitable. If you change your tarrif from Economy 7
to another tarrif you MUST ensure that the circuits
supplying Intelli Heat radiators provide an
unrestricted suply of electricity.
1.
All electrical installation must comply with the
current regulations, standards and code of
practice in effect in the country where the
product is to be installed.
2.
The electrical connection of these radiators
must be carried out using a standardized
junction box. In both kitchens and bathrooms,
the connection box must be installed at least 25
cm above the floor.
3.
These radiators must be supplied with 230 V 50 Hz single-phase and neutral. No other power
supply can be used.
4.
Each radiator must be supplied with a
dedicated power cable protected with a 10 amp
circuit breaker for appliances ranging from 500
W to 2000 W power rating.
INSTALLATION RULES
ELECTRIC RADIATORS IN WET ROOMS
Kitchens and Bathrooms
These radiators are "Class II" insulated
therefore earthing is prohibited.
These radiators are "IP24" rated and are
therefore protected from splash water.
These radiators can be installed in bathrooms
volumes 2 and 3 provided that no electrical unit
can be touched by a person using the bath-tub
or shower.
The circuit supplying the radiator in a wet room
must be protected by a 30 milli amp Residual
Current Device to ensure safety.
Bathroom Volumes
volume 3
volum e 2
CAUTION
These radiators are double insulated therefore
they are not earthed and the radiator cable does
not include an earth wire (yellow green).
Each radiator cable has a Live (BROWN) Neutral
(GREY) and a BLACK wire, which is the PILOT
WIRE.
NEVER CONNECT
connection of the BLACK PILOT WIRE to the
Live, Netural or Earth connections of the power
supply. If this occurs it will damage the
thermostat beyond repair.
The black wire is for connection to an extenal
programmer only, this could be a hard wired or
wireless system, please contact Intelli Heat for
advice on such systems.
If a pilot wire programmer system is not used,
the black wire must be properly
isolated/insulated to avoid any connection to
the live, netural or earth of the power supply.
or aLlow accidental
.
socket outlet. Earthing is prohibited.
A USEFUL TIP!
Installation that involves simply positioning a radiator
next to a power supply will keep the cost of installation
down. For example, by replacing a storage heater with
your new Intelli Heat radiator in the same position.
Should you decide to position your new radiator
where there is not a power supply, the cost of
installation will increase. Therefore, if convenient, it's
best to plan your installation according to the available
power supply.
All Rights on this USER GUIDE are Reserved © No reproduction is permitted - Intelli Heat and intellyGreen are patented brands
0.60 m
.
volum e 1
0.60 m
0.60 m
PAGE 6
L N P
STARTING
SAFETY INSTRUCTIONS
PLEASE NOTE
ELECTRICAL WIRING
We strongly advise that all electrical installation be
carried out by an appropriately qualified electrician.
These radiators are "CLASS II" double insulated.
The electric cable of these radiators do not include an
Earth wire. Earthing is prohibited, ground connection
is strictly forbidden. For thermostats that are equiped
with a pilot wire which is for connection to a pilot wire
programmer, it is essential to ensure that the LIVE and
NEUTRAL wires are correctly connected.
COLOUR CODE: (see diagram below)
Power connection: BROWN to lIVE, GREY to
NEUTRAL, BLACK to, if used, to a PILOT WIRE
programmer ONLY.
RADIATO R CONNECTI ON
Pro gram ming
sy ste m
(ONLY for connection to a
pilot wire programmer)
NEVER connect the PILOT WIRE to a
EARTH, LIVE or NEUTRAL connection.
The BLACK Pilot Wire is for pilot wire
programming use only.
Connection of the PILOT WIRE to the LIVE, NEUTRAL or
EARTH of the power supply will destroy the
thermostat. If the pilot wire is not to be connected to
a pilot wire programmer then it must be correctly
isolated/insulated to ensure that this does not occur.
CAUTION:
Before any installation
or work on the electrical
circuit, you must cut off the
power supply from the
circuit breaker or from the
main circuit breaker.
Always double check to
ensure that no wire is live.
All Rights on this USER GUIDE are Reserved © No reproduction is permitted - Intelli Heat and intellyGreen are patented brands
INSTALLATION INSTRUCTIONS
Check that the radiator is correctly connected to the
electricity supply, then test the various functions of
the thermostat. For temperature control and
programming, please refer to the table of contents to
locate the appropriate instructions for your system.
In the event of faulty operation, first check that the
appliance is properly connected to the power supply.
If everything seems to be in order, you should first
contact the person who installed your system, if they
are unable to assist, you should then contact
the supplier or the manufacturer.
TO AVOID RISK OF ELECTROCUTION:
Do not tamper with, modify or dismantle a radiator,
Figure 1
L = Live
Brown color
N = Neutral
Grey color
P = Pilot wire
Blac k color
the thermostat or any associated control or electrical
system. Do not put any metal object into the
thermostat.
The electrical cable is connected to the system by the
manufacturer, it is not replaceable and is supplied as
a standard length, it should not be extended or
shortened.
Do not pull the electrical cable, twist it or wedge it
behind or in the fins of the radiator.
Should the electrical cable become damaged or the
electrical installation was not carried out correctly or
accordance with the regulations, you are at risk of
suffering serious wounds which could be life
threatening.
If the electrical cable is damaged, it must be replaced
by the manufacturer or by one of their after sales
service personnel, or by a fully qualified electrician
who is familiar with this type of system.
WARNING: To avoid overheating, never cover a
radiator and never position it below a power socket.
These radiators are filled with an accurate quantity of
a special Thermodynamic fluid. Any repairs that
require the fluid tank to be opened must only be
carried out by the manufacturer or by one of their
approved after sales service personnel. The
manufacturer must be contacted in the event of any
leakage of fluid.
Loading...