DL-S41-H2 Quick Install Guide
This guide is for quick installa on only.
For complete owners manual and list of commands, go to www.libav.com or use a
QR reader to access the manual via QR code below.
Rev 181116
Scan QR Code with your Smart-phone or Tablet
11675 Ridgeline Drive
Colorado Springs, CO
80921
Phone: 719-260-0061
Toll-Free: 800-530-8998
Fax: 719-260-0075
DL-S41-H2 Quick Guide
Product Overview
The DL-S41-H2 is an slimline HDMI 2.0b auto switcher with four HDMI video inputs and one HDMI output. This
switcher supports HDMI video resolu ons up to 4Kx2K@60Hz 4:4:4, HDR, and mul channel audio. In addi on
to passing EDID informa on from the display, there are mul ple built-in EDID se ngs to simplify an installa on.
The switcher will de-embed digital stereo audio to provide an analog audio source for an exis ng audio system.
The switcher also supports audio return channel (ARC) for transmi ng audio back to HDMI input and audio
output ports from display device.
When in auto-switch mode, the switcher will switch to an HDMI input as soon as a new source is connected.
When the ac ve is removed, the switcher will select the fi rst source on the lowest numbered input. The switcher
may also be controlled via RS232, IR with the included remote, or from the source bu on on the front of the
switcher.
Package Contents
• DL-S41-H2 HDMI 2.0b Auto Switcher
• Quick Install Guide
• (1) IR Remote
• (1) IR Receiver
• (1) RS232 3.5mm to DB9 adapter cable
• (1) DC5V 1A power supply with US, UK, EU and AU power adapter plugs
• (2) Moun ng ears with moun ng screws
• (4) Plas c cushions
2
Front
DL-S41-H2 Quick Guide
Front and Rear Panels
1 324 5
1. AUTO/SOURCE - Auto / manual mode switching selec on
• Press and hold 3 seconds to switch between switching modes
2. POWER LED - Illuminates RED when power is applied
3. AUDIO MODE LED - Audio mode indicator
• When LED is green, unit is in de-embed mode
• When LED is yellow, unit is in ARC mode
4. SOURCE MODE LED - Switch mode indicator
• When LED is green, unit is in manual switch mode
• When LED is yellow, unit is in auto switch mode
5. HDMI INPUT LEDS - Illuminates GREEN when there is an HDMI input on the corresponding channel
6. FIRMWARE - USB port for fi rmware updates
6
3
DL-S41-H2 Quick Guide
Rear
1
1. HDMI IN 1-3 - HDMI inputs 1 - 3 for HDMI sources
2. (ARC) HDMI IN 4 - ARC compa ble HDMI input
3. HDMI OUTPUT - HDMI output to connect to display technology
4. AUDIO OUTPUT - 3.5mm audio output jack
5. RS232 - 3.5mm serial control output
6. IR IN - 3.5mm IR input port for IR receiver (included)
7. EDID - 4 pin dip switch for EDID se ngs
8. DC 5V - DC barrel port for 5V power adapter (included)
2
3
4 5
6
7 8
4
DL-S41-H2 Quick Guide
Connec vity Instruc ons
1. Verify all components included are present before installa on.
2. System should be installed in a clean environment with proper temperature and humidity.
3. All A/V devices including switcher should be connected together before powering on.
4. Connect HDMI source devices to HDMI inputs
5. Connect an HDMI display device to the HDMI output port
6. Connect the AUDIO OUTPUT port on receiver to audio amplifi er (op onal)
7. Connect the supplied IR receiver to the IR IN port to control switcher with supplied IR remote (op onal)
8. Connect RS232 port for serial control (op onal)
Note: A complete list of RS232 commands are located in the DL-S41-H2 owners manual locate online at
www.libav.com
9. Set EDID dip switch to desired EDID se ng
Note: DL-S41-H2 ships with all dip switches in the OFF posi on or pass through EDID communica on
10. Connect the included power supply to the DL-S41-H2 switcher
11. Power on a ached audio / video and control devices
5
DL-S41-H2 Quick Guide
Cabling Wiring Requirements
RS232 Wiring
Connect the 3rd party controller device RX signal to TX pin of the DL-S41-H2 DB9 breakout cable. Then connect
the controller TX signal to the RX in to complete wiring.
Audio Output Wiring
Below is an audio cable pin-out that is compa ble with the DL-S41-H2 audio output
LEFT
RIGHT
GROUND
6
Technical Specifi ca ons
VIDEO
Video Inputs (4) HDMI
Video Input Connector (4) HDMI type A
Input Video Signal HDMI
Video Output (1) HDMI
Video Output Connector (1) HDMI type A
Output Video Signal HDMI
Input Resolu ons Support-edUp to 3840 x 2160 @ 60Hz, 4:4:4, 8bit color depth
Standards Compliant with HDMI 2.0b & HDCP2.2
AUDIO
Supported output formats PCM 2.0
Audio Output Stereo analog
Audio Output Connector (1) 3.5mm TRS audio jack
Audio Output Impedance 70 Ohms
Frequency Response 20Hz~20K Hz
CONTROL
Control Port / Connector (1) IR / 3.5mm connector
(1) RS232 / 3.5mm connector
OTHER
System Bandwidth 18Gbps
Opera ng Temperature -10C ~ +55C
Storage Temperature -25C ~ +70C
Humidity 10% ~ 90%
Power Supply Input:100V~240V AC; Output: 5V DC 1A
Power Consump on 5 wa s
Dimension (W*H*D) 194mm * 12mm * 81mm / 7.6” * .47” * 3.2”
Weight 180g / .4 lbs
Warranty 5 years
Cer fi ca on CE, FCC, RoHS
DL-S41-H2 Quick Guide
7
Thank you for your purchase.
For Technical Support please call our toll free number at
800-530-8998 or email us at supportlibav@libav.com
www.libav.com
Digitalinx is a brand of:
11675 Ridgeline Drive
Colorado Springs, Colorado
80921 USA
Phone: 719-260-0061
Fax: 719-260-0075
Toll-Free: 800-530-8998
Loading...