Intelix DIGI-HD70-R User Manual
Symptom
Possible Solutions
No signal
Verify that both ends of the twisted pair cables use
No signal
Verify the power supplies are connected to both
Unusual colors in
Power off the destination device and power it back
to force renegotiation.
Important notice:
Do not connect the extender to a
telecommunication outlet wired to unrelated
connected equipment. Ensure all connected
Instructions
Turn off power and disconnect the
ent by following the
DIGI-HD70 Installation Guide
The Intelix DIGI-HD70 extends HDMI over a single twisted
pair cable. The DIGI-HD70 supports a 1080p video signal up
to 70m, as well as 3D and 4K x 2K signals up to 40m.
Built-in surge protection and diagnostic LEDs ensure hasslefree and robust installations. The DIGI-HD70 incorporates
HDBaseT technology.
1.
audio/video equipm
manufacturer’s instructions.
2. Connect twisted pair cable between the
transmitter (DIGI-HD70-S) and the receiver
(DIGI-HD70-R). Ensure T568B straight-thru
wiring.
3. Connect HDMI cables between the display
and the receiver (DIGI-HD70-R).
4. Connect HDMI cables between the source
and the transmitter (DIGI-HD70-S).
5. Connect the included power supplies to the
transmitter and receiver.
DIGI-HD70 Installation Guide
Twisted Pair
Wiring - Use
T568B wiring for
Cat5e/6
connection
between send
and receive
units.
• Do not attempt to disassemble or alter the
extender housing. There are no user-serviceable
parts inside the unit. Doing so will void your
warranty.
• To minimize the possibility of equipment damage
from electrostatic discharge (ESD), all source and
destination equipment must be powered off
during installation.
•
equipment. Doing so may damage the unit or any
twisted pair cabling is straight-through (point-topoint).
• Allow proper ventilation to reduce the risk of
thermal failure.
Troubleshooting
Status LED is off
T568B crimp pattern.
Verify HDMI cables and source and destination
HDMI ports are operational.
the send and receive baluns.
Verify the power LEDs on both the send and
receive units are brightly illuminated.
6. Power on attached audio/video devices.
the video
8001 Terrace Ave.
Suite #201
Middleton, WI 53562
on to force renegotiation.
Unplug and re-plug the HDMI cable from receive
Phone: 608-831-0880
Toll-Free: 866-4-MATMIX
Fax: 608-831-1833
DIGI-HD70 Installation Guide
Technical Specifications
I/O Connections
HDMI
One (1) HDMI Type A Receptacle
Twisted Pair
One (1) 8P8C port (Shielded RJ45)
5V DC Power
One (1) 5.5 mm Outside Diameter, 2.1 mm Inside Diameter Barrel
Supported Audio and Video
Maximum Video Compatibility at 70 m
Deep Color 36/30/24 Bit at 1080p
Maximum Video Compatibility at 40 m
Deep Color 48 Bit at 1080p, 3D, and 4k x 2k
Video Compliance
HDMI, HDCP, and CEC (Consumer Electronics Control)
Embedded Audio
Up to PCM 8 channel, Dolby Digital TrueHD, and DTS-HD Master Audio
Input DDC Signal
5.0 volts p-p (TTL)
Input Video Signal
0.5 to 1.0 volts p-p
HDBaseT Signal Characteristics
Maximum Distance
70 m
Cable Requirements
Solid core shielded Category 5e, Category 6 or greater with TIA/EIA-568B crimp pattern
Bandwidth
10.2 Gbps
Gain
0 dB – 10 dB at 100 MHz
Signal to Noise Ratio (SNR)
> 70 dB at 100 MHz over 100 m
Return Loss
< -30 dB at 5 KHz
Total Harmonic Distortion (THD)
< 0.005% at 1 KHz
Min-Max Signal Level
< 0.3 V – 1.45 Vp-p
Differential Phase Error
±10° at 135 MHz over 100 m
Chassis and Environmental
Enclosure
Painted steel
Dimensions
110 mm x 76 mm x 24 mm (4.33 in x 2.99 in x 0.95 in)
Shipping Weight
0.5 kg (1.1 lbs)
Operating Temperature (Environment)
0° to +40° C (+32° to +104° F)
Operating Temperature (Chassis)
31° C (88° F) (S); 38° C (100° F) (R)
Operating Humidity (Environment)
20% to 90%, Non-condensing
Storage Temperature (Environment)
-10° to +60° C (+14° to +140° F)
Storage Humidity (Environment)
20% to 90%, Non-condensing
Power, ESD, and Regulatory
Maximum Power Consumption
4 watts (S), 11 watts (R)
Power Supply
5vDC / 2A
ESD Protection
15kV
Regulatory
CE, RoHS
Other
Standard Warranty
2 Years
Diagnostic Indicators
Link and power LEDs
DIGI-HD70-S, DIGI-HD60C-S, DIGI-HDE-S, FLX-BO4, FLX-BO4A, ASW-WP, DIGI-88B,
DIGI-44B, DIGI-P123, DIGI-P52
DIGI-HD70-S Compatible Receivers
DIGI-HD70-R, DIGI-HD60C-R, DIGI-HDE-R, FLX-BI4
Included Accessories
US Power Supply, Installation Guide
Mounting Solution
DIGI-PMK1
Distances and p icture qualit y may be affec ted by cable grade, cable q uality, source and destination equipment, RF and electrical interference, and cable patches.
DIGI-HD70-R Compatible Transmitters
8001 Terrace Ave.
Suite #201
Middleton, WI 53562
Phone: 608-831-0880
Toll-Free: 866-4-MATMIX
Fax: 608-831-1833
Loading...