Integrated Controls, Inc. DMX-iT 524 User Manual

Integrated Controls, Inc

.

DMX-iT 524 User Guide

Rev 1.32

1. Master

The Master fader is a
Grand Master which acts as
a final Level for all output
levels of all functions.

The other Masters; Live,
Scene A, Scene B are
subject to the Master.

2. Bump buttons

Bump buttons are below

each of the 24 channel
faders

Pressing a Bump button
will immediately raise that
channel to full level subject
to the Masters.

3. Live Basic Operations
On the left is the Live Master (LM) which controls the overall level for the
basic Live operation of the 24 channel faders.

Set the pushwheel to a starting Address, the LED will start to blink to indicate
a mismatch between the current Live address and what was just set.
Press Change, the LED stops blinking to indicate the current address is Live.

Fader1 will now be at Address, Fader2 will be at Address+1, etc.

The Live “scene” is always output (subject to Live Master) even when Scene
memories are in use.

When you change the current Live Address and don’t press Change the Red LED will blink to
remind you the address is not the current live address, when you change back to the current Live
address or press Change the Red LED will turn off.

Live is still at Address 001 and is still outputting and subject to Live Master.

At this point you probably want to set the Address back to the current Live
Address, 001 in this example, the Red Change LED will turn off to tell you
have restored the current Live Address.

4.2 Delete Scene
Same button sequences as Write except use the Delete button:
Hold Delete, Tap A, release Delete, Tap Delete, the blinking will guide you.

6. Special case addresses

6.1 Clearing the Universe

Sometimes you may want to send 0’s for the entire 512 universe.
This can be useful if dimmers retain values that you wish they hadn’t.

Set the the Address to 999 (don’t press Change), hold Delete for 3 seconds, LED blinks, release.
All 512 channels were sent 0 levels, the scenes defaulted to off. Set the pushwheel back to your
Live Address. As of v1.31 holding down both Bumps 1&2 during power up will do the same
clearing operation. (Note that a starting Live address off 500+ w/ Master down has the same effect
of clearing the universe)

a the DMX 512 universe is also cleared at power up (as of v1.32).

7. Other Features and notes

7.1 Battery and power operations

Professional 5pin XLR

1 Ground
2 Data –
3 Data+
4,5 No connect

The internal rechargeable battery runs, about 2 days with a full charge while
operating continuously!

LED indication is provided on the rear panel for Charge Status & Low Batt.

A 5V DC adapter is provided (model PS-1512) with a 4.0 x 1.7 barrel connector
(EIAJ 2 size). The adapter is worldwide AC voltage input with North American
prongs and is ultra mini in size.
The adapter will simultaneously operate the unit and charge the battery.
Full charge time is few hours, useful charge can be had in tens of minutes (it
will charge slightly faster with the unit OFF).
The Charge light will go off when fully charged.

A MICRO B USB power input is also provided, external portable battery pack
“chargers” as used for smartphones or a laptop may also be used as a power
source and as a charging source for the internal battery.
So in a pinch with a discharged internal battery and no handy AC around you
can be instantly running by attaching here (no USB cables are supplied).

Ultra compact 24 channel
DMX controller.

Rugged, lightweight with
integral protective
sidewall barriers.

Integrated Controls, Inc.

San Francisco, CA 94110

www.dmxit.com [e-mail]