InStep Safari series Operating Instruction

Operating Instructions Safari™ Series

Keep this manual for future reference. If you sell this stroller or give it
away, make sure you give this manual to the new owner. Ask them to
read instructions completely.

IMPORTANT: Read and follow these Safety Rules and Assembly Instruc­tions
before operating stroller. If you have any questions concerning the safe
use of this product, contact Pacific Cycle at 1-800-242-6110, M-F,
8:00 a.m.-5:00 p.m. CST or visit us at www.instep.net or E-mail us
at [e-mail] before using.

IMPORTANT: Tires are shipped deflated, DO NOT OVERINFLATE.
Please inflate slowly, with short bursts, to 20-25 PSI maximum.
25 PSI will provide a comfortable ride for your child.

PLEASE DO NOT RETURN PRODUCT TO THE STORE. To ensure prompt and
correct handling of problems, or to answer questions, please contact us at
either our
Toll-Free Customer Service number (1.800.242.6110) or E-mail us at info@
instep.net. Service will be quicker if you have your model number and
date code (found on the product and box) along with this instruction sheet
ready when calling.
If you have any questions concerning the safe use of this product, please
contact us immediately.

*images may appear different than your product. The assembly process will be the same.
*single pictured

Safety Rules:

WARNING: Failure to follow these warnings and assembly

instructions could result in serious injury or death.

· Immediately discard any plastic wrapping.

· Never allow children to fold, assemble or disassemble the stroller.

· Maximum weight capacity for the Single stroller is 50 lbs. or 22.7 kgs.
Double is 100 lbs or 45.4 kgs. However, the weight of one child should
not exceed 50 lbs. Excessive weight may cause a hazardous, unstable
condition if this load is exceeded. Maximum height of the child shall not
exceed 38” or 96 cm.

· Stroller is not for use with children under 6 months of age.

· Never place child in the stroller with their head forward and feet rear
ward unless they are placed in an approved infant carrier that is made
specifically for this stroller.

· Avoid serious injury from falling or sliding out. Always use seatbelt.

· Never leave child unattended.

· Never use this stroller with roller skates or in-line skates.

· Never allow stroller to be used as a toy or allow children to give rides
to others.

· Never use stroller if it becomes damaged.

· Always be aware of traffic around you when walking

· Always engage brakes when you stop or when you let go of handle.

· Accessories or parcels placed in or on the stroller may cause it to be
come unstable.

· Maximum weight for objects in bottom basket is 5 lbs. or 2.2 kg.
Rear pouch is 2.2 lbs or 1 kg. Excessive weight may cause a
hazardous, unstable condition.

· To avoid burns, never put hot liquids in the parent or child tray.

· To prevent tipping over do not place more than 2 lbs or 1 kg on either
parent or child tray.

· Child may slip into leg openings and strangle. Never use in a reclined
carriage position unless T-shield/ waist strap placement has been
re-adjusted.

· Care must be taken when folding and unfolding the product to prevent
finger entrapment.

frame

swivel lock

swivel wheel

front fender

parking brake

basket

child tray

(napper bar on

double)

canopy

handle

handle adjustment

parent console

rear wheel

{Figure 1.a}

Parts List:
Description Qty.

Frame assembly 1
Fender 1
Fender Screws 4
12” Front Wheel Assembly 1
16” Rear Wheel Assembly 2
Child tray (single)/napper bar (double) 1
Parent tray (single) soft console (double) 1

Tools Required: Phillips screw driver.

Unfold Stroller

Remove all packing material and dispose of it properly. Release storage latch
located on side of stroller. (Figure A) Grasp frame as shown and open until the
side latches engage (Figure B).

Rear Wheel Assembly

Turn stroller onto its side. Grasp rear wheel in one hand, slide wheel’s axle into
hole in rear of frame (Figure C1). Check to see that the wheel is properly inserted
by firmly pulling on the wheel, the wheel should not come off if fully inserted/
locked. Repeat for other side. To release wheel, push up on axle release lever
and pull off wheel (Figure C2).

Front Fender Assembly
Turn stroller upright onto its rear wheels, tip stroller back so the handlebar is

down on the ground and the front fork is up. Align the fender’s tabs with the
holes on the front frame. Insert the included screws into the hole and tighten with
a Phillips screwdriver, repeat for the other 3 holes (Figure D).

Front Wheel Assembly

While the stroller is still tipped back, attach the front wheel by loosening the
wheel’s quick release (Q/R) lever on the front wheel far enough to allow the axle
to slide into the front fork (Figure E). Align the tab washer’s tab into the small hole
on the outside of the front fork. With wheel’s Q/R lever in open position, hand
tighten the cone nut until almost tight, then flip the wheel’s Q/R lever backward to
the closed position to lock wheel in place. Note: this step may require minor ad­justment until the Q/R lever flips back with firm pressure. Pull outward on wheel
to ensure it is locked in place. Note: The black hex nuts should be on the inside
of the frame. These are factory set and should not require adjusting.

Operating Instructions Safari™ Series...page 2

To unfold stroller:

Release storage latch located on side of stroller (see Figure H2), continue
unfolding until side latches engage.

To engage rear brakes: Step lightly on the center brake bar or directly on the
brake to engage brakes. To disengage, lift up on brake bar. (Figure I)

PROPER USE OF SEAT BELTS & SHOULDER STRAPS:
WARNING: Avoid serious injury from falling or sliding out.

Always use seatbelt.
Place child in seat. Make sure T-shield is between the child’s legs.When child is

seated, place shoulder straps over the child’s shoulders.
Slide waist straps through lower loops of shoulder straps, bring lap belt

ends together and clip into place around child’s waist. Adjust waist and
shoulder straps for snug fit.

SHOULDER HARNESS

The shoulder straps for the harness are adjustable depending on the size of your
child. The shoulder straps are used with a loop system that puts the straps at 3
different sizes. When the strap is under both sets of loops (Fig 1), the smallest
length of strap is able to be used for smaller children. If more slack is needed
back the strap out from under the bottom loop and lay it over the loop (Fig 2).
If still more slack is required back the strap all the way out of the loops for the
maximum length of the shoulder strap (Fig 3).

Installing Child Tray (single)/Napper Bar (double)

Position the child tray/napper bar as shown with the tabs on the bottom. (Figure
F1) Push in until tabs lock in place. To remove child tray/napper bar, push up on
bottom tabs and pull off tray.

WARNING: To avoid burns, never put hot liquids in the trays. To prevent tipping
over do not place more than 2 lb. (1 kg) on the trays.

Step 6. Installing Parent Console

On single model: Snap the parent tray onto the handle bar aligning the tray’s
holes with the handlebar’s knobs as shown (Figure F2).

On double model: The parent pouch will have a flap with two snaps. Wrap the
flap around the handlebar at your desired position and fasten the snaps.

WARNING: Always remove child from stroller before folding.
To fold stroller:

On single model: Pull the one-hand-fold handle toward the stroller handle and the
stroller will automatically begin to fold. (Figure H1). Continue folding, pushing
frame together and hook the storage latch (Figure H2)

On double model: Slide the lock button to the left while pulling in the folding
lever (Figure H3). Continue folding, pushing the frame together and hook the
storage latch (Figure H2).

NOTE: There is a secondary folding mechanism to prevent accidental folding lo­cated near the left wheel on the frame. Push this lever down to release the frame.

Operating Instructions Safari™ Series...page 3

Figure 1 Figure 2 Figure 3

Operating Instructions Safari™ Series...page 4

To recline seat:

To recline, pull on the center ring of the recline buckle on back of the seat to the
desired recline position.

To place seat in upright position, hold the 2 cords and push up on the recline
buckle located on the back of the seat; you may have to push on the ring to lock
the cords in place.

WARNING: Child may slip into leg openings and strangle.
Never use in a reclined carriage position unless T-shield and shoulder
strap have been re-adjusted to the new seat position.

To adjust handle height (Single models only):
While pushing the handle buttons in rotate handle to the desired height. (Figure L)

To adjust the child leg rest area:

Pull up on the side levers and adjust leg rest to the desired height (Figure M).

To lock the front wheel from turning:

Flip lever on the front wheel to keep the front wheel from turning. To unlock, flip
lever opposite way (Figure N).

CARE AND MAINTENANCE

Check fasteners after one hour of use; check all fasteners to make sure they are
secure. Adjust if necessary. Periodically check the stroller to ensure that it is in
good operating condition.

To adjust the stroller from pulling to the left or right (not rolling straight): Loosen
the front Q/R axle and point the front wheel in the opposite direction the stroller
is pulling, then tighten Q/R lever.

NOTE: Sometimes it is a very slight adjustment to eliminate the pulling and
this step may need to be repeated.

To clean seat and canopy: If light cleaning is required, use a soft cloth with warm
water and mild soap then air dry. Do not put in washing machine. Do not put in
dryer. DO NOT BLEACH.

To clean frame: Wipe using a soft cloth with warm water and mild soap. Air dry.
DO NOT USE polish or abrasives.

If you have any questions concerning the safe use of this product,
please contact Pacific Cycle before using:

1.800.242.6110
8am-5pm CST, Monday-Friday, or MAIL to:

Pacific Cycle Inc.
4730 East Radio Tower Lane
Olney IL 62450

Tel: [phone]
or visit us at www.instep.net
E-mail: [e-mail]

ONE YEAR LIMITED WARRANTY

Pacific Cycle warrants this product to be free of defective materials and work­manship for 1 year from the date of original purchase.

THIS LIMITED WARRANTY IS THE ONLY WARRANTY APPLICABLE
TO THIS PRODUCT, AND IS EXPRESSLY IN LIEU OF ANY OTHER
WARRANTY. ANY IMPLIED WARRANTIES, INCLUDING ANY
WARRANTY OF MERCHANTABILITY AND WARRANTY OF FITNESS
FOR A PARTICULAR PURPOSE IS LIMITED IN DURATION TO THE
DURATION OF THIS EXPRESS WARRANTY. This limited warranty gives

you specific legal rights and you may also have other rights which may vary
from state to state.

This warranty is extended only to the original consumer purchaser for
non-commercial use and does not cover tires or tubes, grips, brake shoes,
or other wear part, ordinary wear and tear, abuse, misuse, neglect, rust, theft,
or damage due to accident.

PACIFIC CYCLE, INC., IS NOT RESPONSIBLE FOR INCIDENTAL OR
CONSEQUENTIAL DAMAGES. THIS LIMITED WARRANTY DOES NOT
COVER ANY PERSONAL INJURIES, DAMAGE TO, OR, FAILURE OF THE
PRODUCT OR ANY OTHER LOSSES DUE TO ACCIDENT, ABUSE,
MISUSE, ALTERATION, NEGLECT, RUST, NORMAL WEAR AND TEAR,
IMPROPER ASSEMBLY, IMPROPER FIT, IMPROPER MAINTENANCE
OR USE OF UNAUTHORIZED REPLACEMENT PARTS NOT DESIGNED
FOR THE PRODUCT.

To make claim under warranty, notification of such defect must be given to Pacific
Cycle, Inc at the address stated on the previous page. You will be instructed on
how the product or part needing replacement should be shipped postpaid to
Pacific Cycle, Inc.

Operating Instructions Safari™ Series...page 4