InStep RS100 User Manual

1

Keep this manual for future reference. If you sell or give this convenience

stroller away, make sure you give this manual to the new owner.

Ask them to read instructions completely.

CONVENIENCE STROLLER

Operating Instructions

Important: Read and follow these Safety Rules and Assembly Instructions before operating stroller. If you

have any questions concerning the safe use of this product, contact InSTEP, LLC at 1-800-242-6110, M-F,
8:00 a.m. – 5:00 p.m. CST or visit our web site at www

.instep.net or email us at inf

[e-mail] before using.

Safety Rules:

WARNING: Failure to follow these warnings and assembly instructions could result in

serious injury or death.

WARNING: Immediately discard any plastic wrapping.

WARNING: Never allow children to fold, assemble or disassemble the stroller.

WARNING: Maximum weight capacity for the Single stroller is 40 lbs. or 18.2 kg.

WARNING: Never place child in stroller on their back with their head forward and feet rearward.

WARNING: Avoid serious injury from falling or sliding out. Always use seatbelt.

WARNING: Never leave child unattended.

WARNING: Never use this stroller with roller skates or in-line skates.

WARNING: Never allow stroller to be used as a toy or allow children to give rides to others.

WARNING: Never use stroller if it becomes damaged.

WARNING: Always be aware of traffic around you when walking.

WARNING: Always engage brakes when you stop or when you let go of handle.

WARNING: Accessories or parcels placed in or on the stroller may cause it to become unstable.

WARNING: Maximum weight for objects in bottom basket is 5 lbs. or 2.2 kg. Excessive weight may

cause a hazardous, unstable condition.

WARNING: Child may slip into leg openings and strangle. Never use in a reclined carriage position

unless T-shield/ waist strap placement has been re-adjusted.

2

IMPORTANT

We appreciate your purchase of one of our many fine products. We are sure that you will be satisfied with
your selection. Great care and effort has been taken, however occasionally problems may occur. PLEASE DO
NOT RETURN PRODUCT TO THE STORE. To ensure prompt and correct handling of problems, or to answer
questions, please contact us at either our Toll-Free Customer Service Number or Email us at our number list­ed below. Service will be quicker if you have your model number (found on the product and box) along with
this instruction sheet ready when calling. If you have any questions concerning the safe use of this product,
please contact us 1-800-242-6110 press “1” for customer service and then “2” to speak to a representative or
Email us at inf

[e-mail] or visit our web site at www.instep.net.

For Model CS300 Only

Tires are shipped deflated, DO NOT OVERINFLATE. Please inflate slowly, with short bursts, to 20-25 PSI
maximum. 25 PSI will provide a comfortable ride for your child.

Parts List

A

B C1

Description

Qty.

Frame Assembly 1
Front Wheel Assembly (Dual wheels) 2
Rear Wheel 2
Rear Axle Assembly 1

Description

Qty.

Rear Wheel Kit consists of:

Rear hub/brake cog 2
Rear axle retaining clip 2
Rear axle cap 2
Rear wheel hub cap 2

C2

Stroller Assembly Instructions

Step 1. Unfold Stroller

Release storage latch located on side of stroller (Figure A).
Grasp frame as shown and open until side latches engage
(Figure B).

Step 2. Front Wheel Assembly

Turn stroller on its side. Slide the front wheel assembly onto
one of the front legs. Push until the wheel assembly locks into
place. Repeat for other side (Figure C1). Pull firmly on each
wheel assembly to ensure that they are securely attached.
Note: to remove front wheels, press the tab located beneath
wheel assembly (Figure C2).

Storage Latch

Side Latch

Front Leg

Swivel Lock

Wheel
Release
Ta b

Front Dual Wheel

3

E1

E2 F1

F2 F3

F4

Step 3. Rear Wheel
Assembly

Turn stroller onto its front
as shown (Figure D).
Slide the rear axle
assembly onto frame
as shown (Figure E1).
Note: to remove rear axle
assembly push up the
plastic baffles while
pushing in the silver
release button pull
off the axle assembly
(Figure E2). Place rear
brake cog on the rear
wheel – turn the cog so
the grooves line up with
the ribs on the wheel
sprocket, then push the
adapter on. Slide the
wheel with brake cog
onto the axle (Figure F1).
Place the wide end of the
retaining clip onto the
grooved end of the axle,
then press to snap into
place (Figure F2). Posi­tion the axle cap over
retaining clip and then
press to snap into place
(Figure F3). Place the
hubcaps on the wheels –
align the hubcap tabs
with the holes in the
center of the wheel,
then press into place
(Figure F4). Repeat for
other side.

D

Rear Axle

Rear Axle
Assembly

Rear Axle
Assembly
Release
Buttons
Both Sides

Rear Axle

Rear Axle
Assembly
Release
Button

Retainer
Clip

Retainer
Clip

Axle Cap

Axle Cap

Hub Cap

4

Use Instructions

WARNING: Always remove child from stroller before folding.

To fold stroller:

Step 1. Retract canopy and fully recline seat before folding

(Figure H). (See “To adjust 3-position recline seat”)

Step 2. Push in side buttons and lift slightly upon side handles
as shown, stroller will automatically begin to fold (Figure I).

Step 3. Continue folding by pushing frame together until
storage latch engages (Figure J).

To unfold stroller:

Release storage latch located on side of stroller, continue
unfolding until side latches engage (See Figure J).

To engage rear brakes: Step lightly on the center brake
bar to engage brakes. To disengage, lift up on brake bar
(Figure K).

Step 4. Mount child
napper bar

Position bar as shown
with tabs on the bottom.
(Figure G1) Push in until
tabs lock in place.To
remove napper bar,
push up on bottom tabs
and pull off napper bar
(Figure G2).

G2

H

J K

G1

Step 5. Adjust Canopy

Push or pull canopy too the desired position.

I

Napper Bar
Release Tab

Linked
Rear Brake

5

To place child in stroller:

Always engage rear brakes so stroller is steady. Lift canopy
from both sides and rotate back. Place child in stroller with
the T-shield between the child’s legs. Fasten the waist buckle.
Adjust belt so that it fits snugly around the child’s waist
(Figure L). (Note: To release, squeeze sides of buckle)

WARNING: Avoid serious injury from falling or sliding

out. Always use seatbelt.

To adjust 3-position recline seat:

To fully recline seat, pull up on the recline bar as shown.
(Figure M) To position seat upright, push back of seat until
side tabs fall into side notches.

WARNING: Child may slip into leg openings and
strangle. Never use in a reclined carriage position unless
T-shield /waist strap have been readjusted to the seats
new position.

For Models CS150T, CS200 and CS300

Child’s Convenience Tray

The napper bar must be used when using the child’s tray.

Step 1. Snap the child’s tray onto both side latches as
shown (Figure N).

P

arent’s Convenience Tray

WARNING: To avoid burns, never put hot liquids
in the parent tray. To prevent tipping over do not place
more than 3 lb. or 1.4 kg on parent tray.

Phillips screw driver is required for installation.

Step 1. Fold the tray several times in the hinge area to break
in the hinge (Figure O1).

Step 2. Align the holes on the tray with knob on frame and
snap tray into place over knob. Repeat for other side
(Figure O2).

L

M

N

O2O1

Tr ay
Centering
Supports

Side
Clamp

Flex
Hinge

Parent Tray

Knob

6

1-800-242-6110

8am-5pm CST, Monday-Friday, or MAIL to:

2425 Enterprise Drive, Suite #900

Mendota Heights, MN 55120

Tel: [phone]

or visit our web site at www.instep.net

email: [e-mail]

WARNING:

If you have any questions concerning the safe use of this product,

please contact InSTEP LLC before using:

Care and Maintenance

Check fasteners

After one hour of use, check all fasteners to make sure they are secure. Adjust if necessary.
Periodically check the stroller to ensure that it is in good operating condition.

To clean seat and canopy:

If light cleaning is required, use a soft cloth with warm water and mild soap then air dry. Do not put
into washing machine. Do not put in dryer. DO NOT BLEACH.

To clean frame:

Wipe using a soft cloth with warm water and mild soap. Air dry. DO NOT USE polish or abrasives.

Accessory Name Description Item Retail Ship & Qty. Total

Number Price Handling Cost

Child Tray--Blue Fits on all InSTEP Convenience Strollers napper bar. Offers additional convenience. 13-SA066 $10.00 $3.00

Parent Tray--Blue Fits on all InSTEP Convenience Strollers handle bar. Parent console tray with two 13-SA068 $10.00 $3.00

cup/bottle holders and one storage tray.
Convenience Stroller Fits on all InSTEP Convenience Strollers. For use with the CS100, CS150T, 13-SA070 $14.99 $3.00
Weather Shield CS200 and CS300. Made of heavy duty clear vinyl with black trim.
Convenience Stroller Fits on all InSTEP Convenience Strollers. For use with the CS100, CS150T,CS200 13-SA072 $10.99 $3.00
Bug Screen and CS300. Made of polyester mesh.

MN Residents add 6.5% Tax Total

All prices are US Funds, Canadian Tax/Duty not included.

Order by any of these 4 convenient ways: VISA or Master Card Only
* Mail this form along with check or VISA or Master Card
number listed to: InSTEP LLC

2425 Enterprise Drive Card # Expiration Date

Suite 900

Mendota Heights, MN 55120
* Fax this form along with your credit card information to: Cardholder Signature
[phone]
* Call our customer service department at Ship to Name:
1-800-242-6110 or [phone]
* Order on line at our web site www.instep.net Address:

Depending on your location, allow 7-10 business days for shipment. City/ST/ZIP

Phone#

To Place Order, Call 1-800-242-6110