Fall Sensor – FS906ANEL-IC
1
LED Off
Standby Mode
1 Red Flash
Replacement Battery Inserted
1 Red, then 1 Green Flash
First button press after replacing
battery
1 Green Flash
Transmitting with Good Battery
1 Red Flash
Transmitting with Low Battery
Instant Care
This Fall Sensor is designed for a user to push the button for help at any time. It can also
automatically1 activate an emergency alarm if it detects a fall in the event that the user is
unable to trigger an alarm by pressing the button.
A. Usage Recommendation
1. For best results, the Fall Sensor should rest at the center of the user’s breastbone
2. Wear the Fall Sensor on the outside of all articles of clothing.
3. Carefully place the Fall Sensor on a table or nightstand when you are not using it in
order to avoid activating an alarm.
B. Identifying the Parts
1. Emergency Button
Pressing the Emergency Button for 0.5 sec will activate the Control Panel, causing it to dial
an emergency call or alarm (CID event code: 101).
2. LED
3. Lanyard
The lanyard length is adjustable by holding this piece and pulling the loop to increase or
decrease the lanyard length.
4. Battery Compartment Cover
1. When replacing the battery, ensure that the positive side (+) of the battery is facing
outward.
2. After replacing the battery, press and hold the Emergency Button until you see the LED
flash RED then GREEN.
Note: Fall Sensors do not detect 100% of falls. If you are able to do so, you should always press the button if you need help.
C. Low Battery Detection and Supervision
Fall Sensor features Auto Low Battery detection and Supervision.
When a battery is below the low battery threshold, the Fall Sensor will automatically
send a low battery supervisory message every two hours.
D. Testing
When testing, do not activate the Fall Sensor twice within a 10-second interval.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Caution:
To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance may void the user's authority to operate this equipment.
NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC ID: XO8-FS906ANEL-1 rev. A01
Loading...