Instanta Titan Pro Bulk, MOD18 Installation And User Instruction Manual

Titan Pro Bulk Water Boiler

MOD18

INSTALLATION and USER INSTRUCTION MANUAL

Serial Number: __________

IB18 - Issue: 3

CONTENTS

1.0 INTRODUCTION

2.0 ACCESSORIES (check list)

3.0 WARNING AND PRECAUTIONS

4.0 INSTALLATION

4.1 Work surfaces and location

4.2 Water connection

4.3 Electrical connection

4.4 Overflow/waste

5.0 INITIAL COMMISSIONING

6.0 USER INSTRUCTIONS

6.1 Daily Operating Instructions

6.2 Cleaning

6.3 Maintenance

7.0 TECHNICAL SPECIFICATION

8.0 DE-SCALING

9.0 FAULT DIAGNOSIS (service warning light)

1.0 INTRODUCTION

Your new Water Boiler is designed to give years of trouble-free service provided that
the instructions contained in this manual are followed.

Instanta products are energy efficient, simple to operate and easy to service.
Installation is straightforward but it is recommended that this, be carried out by a

properly qualified fitter.

2.0 ACCESSORIES

The new boiler is supplied with the following components and should be verified
before installation:

1. Non-toxic flexible hose assembly (WRAS approved)

2. One chrome plated swivel-dispense arm (2 if requested on order)

IMPORTANT: Please read carefully all the instructions before commencing
with the installation and commissioning of the appliance.

3.0 WARNINGS AND PRECAUTIONS

Please read the following carefully before commencing work on this equipment.
A competent installation engineer, in accordance with the installation instructions of

this appliance and all relevant local and national standards including the following
must install this appliance:

 Health and Safety at Work Acts
 IEE regulations
 Local and National Building Regulations
 BS Codes of practice
 Water Supply Regulations

Your new water boiler is designed to provide a constant source of near boiling water
for the preparation of hot drinks. THIS IS VERY HOT

All personnel must be provided with sufficient and appropriate training in the safe
use of this appliance.

In line with Health & Safety requirements we recommend that a risk assessment be
carried out after the boiler has been installed.

A warning notice displayed next to the machine is often helpful in notifying users that
the appliance contains and dispenses near-boiling water.

During normal use of the boiler, certain surfaces will become hot (especially the draw
off taps and swivelling dispense arms). Care should be taken to avoid potential injury
from burns and scalding whilst operating the appliance.

Scale formation within hot water appliances is problematic and more so in hard water
areas. Damage to the appliance caused by excessive scale build-up may invalidate
the warranty – see notes on de-scaling.

Drawings, parts list, circuit/wiring diagrams are the sole property of Instanta Limited
and must not be reproduced without their consent.

This appliance is not intended for use by persons (Including Children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be supervised to ensure they do
not play with the appliance