Instanta DB500, DB1000 Installation And User Instructions Manual

SureFlow Touch
DB500 & DB1000

Auto-Fill Catering Water Boilers
with Push Button Dispense

Installation And User Instructions

INSTANTA LIMITED
Canning Road, Southport, Merseyside, PR9 7SN
Tel: [phone] Fax: [phone]
IB90 - ISS: 01

The Professional’s Choice

CONTENTS

CONTENTS, INTRODUCTION & SAFETY INFORMATION 2

ENVIRONMENTAL INFORMATION & DELIVERY CHECK-LIST 3

TECHNICAL SPECIFICATION 3

INSTALLATION 3

OPERATION 4

OPTIONAL TIMED DISPENSE (with Top-up facility) 5

REGULAR DAILY USE 5

OPTIONAL FILTER MONITOR 5

PREVENTATIVE MAINTENANCE & CLEANING 6

MAINTENANCE, SPARES & SERVICE INFORMATION 6

SERVICE WARNINGS & FAULT DIAGNOSTICS 7

GUARANTEE 8

Introduction

Dear Customer,

Thank you for purchasing this Instanta product.

Your new water boiler is designed to give
you years of trouble-free service provided
that the instructions contained in this manual
are followed.

All new series Instanta products are energy

ecient, simple to operate and easy to service.

Find out more about Instanta products at

www.instanta.com

Safety Information

Please read the following
carefully before starting work
on this equipment.

A competent person should install this appliance
in accordance with the installation instructions
for this appliance and all relevant local and
national standards including:

• Health & Safety at Work Act

• IEE Regulations

• Local & national Building Regulations

• BS Codes of practice

• Water Supply Regulations

VERY HOT WATER – Your new SureFlow
Touch dispense boiler is designed to provide a
constant source of near boiling water, which can
be dispensed for the preparation of hot drinks.

• The SureFlow Touch appliances are ideal for
self-service however, they are not intended
for use by persons (including children)
with reduced physical, sensory or mental
capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of
the appliance by a person responsible for their
safety. Children should be supervised to ensure
they do not play with the appliance.

• Care should be taken to avoid potential injury
from burns and scalding whilst operating
this appliance. The LCD display on the
front of the appliance shows the message
“CAUTION HOT WATER” reminding users to
exercise care when dispensing drinks.

• In-line with Health & Safety requirements, we
recommend a risk assessment be carried out
after the boiler has been installed.

• Always disconnect the unit from the power
supply before servicing.

• The appliance must be earthed.

• Keep these instructions in a safe place near

the unit for future reference.

2

Environmental
(Information On Disposal For
Users Of Waste Electrical
& Electronic Equipment)

The “crossed out wheelie bin” symbol on
this product means that discarded electrical
and electronic products should not be mixed
with general waste. Disposing of the product
correctly will help to save valuable resources

and prevent any potential negative eects

on human health and the environment which
could otherwise arise from inappropriate waste
handling. For proper treatment, recovery and
recycling of end-of-life products, please contact
your dealer or supplier for further information,
or local authority for details of your nearest
designated collection point.

Delivery Checklist

Before starting installation, check that you have
the following parts;

• Catering Water Boiler

• Drip-tray

• Drip-tray drain tting

(optional - for connecting front drip-tray
to a permanent waste/drain)

• Tapered rubber bung
(optional - for blanking o front outlet
if rear-overow outlet is preferred)

• White water inlet hose (3/4”BSP connection)

• User instructions

Technical Specification

Installation

The boiler must be installed on a horizontal

work surface with sucient strength to support

its weight.

Locate in an area where there is adequate space
to use the boiler safely (e.g. free from risk of
congestion and tripping hazards).

Do not block ventilation holes in boiler case.

Connection to Mains Water Supply:

Connect the WRAS approved water lling hose

supplied (¾” BSP) to the inlet connection point
on the underside of the boiler and the other end
to the mains water supply, via an accessible
isolating tap with a ¾”BSP thread.

IMPORTANT: If micro-bore pipe is used instead
of the inlet hose supplied, the size must be

minimum OD ⅜”(10mm).

The water supply must have a pressure not
exceeding 7bar (96psi), and no lower than 2bar
(28psi) NOTE: If your water pressure exceeds

7bar, t a suitable pressure reduction valve.

We regret that Instanta cannot be held
responsible for any machine malfunctions
if the water pressure exceeds that
stated. If in doubt, consult your water
supply company.

Electrical Connection:

The boiler must be Earthed.

Your machine is supplied with a standard 13amp
bonded plug with a 13amp fuse.

3

Model DB500 DB1000

Width 240mm 240mm

Depth 522mm 522mm

Height 445mm 545mm

Power Rating 3.0kW 3.0kW

Weight (Empty) 10.9kg 12.3kg

Weight (Full) 19.8kg 26.5kg

Water Inlet Pressure: 2 to 7 Bar 2 to 7 Bar