Inspiration Tecotherm Neo Quick Setup Manual

Tecotherm Neo

Quick Set-up Guide

Prior to operation: Refer to Tecotherm Neo Instructions for Use.

You will need:

Tecotherm Neo

TECOmed Coolant Fluid

Fill-Up Set

Connecting Hoses

Aqua Pad/ Wrap Mattress

Interlayer

Pre-Fill Mattress

A minimum volume of 250 ml TECOmed fluid must be filled into mattress

Connect the male mattress connectors to the female connectors of the

fill-up bottle

Turn bottle until cap is directed downwards and keep it in a position 0.5m

higher than the mattress

Fill-Up the Tecotherm Neo with TECOmed fluid

Ensure mattress hoses are disconnected from the lower pair of device ports (6)

Undo fill-up bottle and fill with TECOmed fluid up to the 450 ml mark

Connect fill-up set to refill port connector counterparts at the device interface (7)

Green marked connector always fits in to the right hand side port.

Turn on the Tecotherm Neo, select and start treatment mode

“Constant mattress temperature”

Turn bottle until cap is directed downwards

Wait until the fluid level inside fill-up bottle stops falling

Now quit treatment mode

Attach the prefilled mattress to hoses and connect to lower device ports (6)

Connect the green marked male connector of the fill-up bottle to the right refill

port connector. This time do not connect the left hand male connector

Select “Constant mattress temperature” and fill the Tecotherm with another

100 ml of TECOmed fluid

Disconnect fill up set

Note: Move mattress around to ensure all air bubbles have been removed.

Optional:

Rectal Probe

Skin Probe

Treatment Modes

In the main menu select the treatment mode required by scrolling to one of,

Complete Treatment Mode, Servo Mode or Constant Mattress Temperature Mode

Once selected, scroll down and select the parameters to be changed

as appropriate

Once all parameters are selected press start

Note: If using either servo mode you will be asked to insert a rectal probe into the
patient and connect to the Tecotherm Neo, if doing so it is recommended to do so
by approx 6 cm without forcing the probe so as not to cause internal damage to t
he patient.

Caution: In servo modes the Tecotherm Neo first pre-conditions the mattress
temperature, once rectal probes are inserted press ‘START’ to commence servo
mode otherwise the Tecotherm Neo stays in constant mattress mode.

FEMALE CONNECTORS

NON- RETURN VALVE

GREEN CONNECTOR

(7) FILL UP CONNECTION*

PORTS

(T5) ALARM SILENCER*

(1) POWER ON/OFF*

(6) MATTRESS

CONNECTION PORTS*

*Numbers relate to those shown
in the Instructions for Use.

Tecotherm Neo Quick Set-up Guide