Insignia NS-GEMW531 Quick Setup Guide

QUICK SETUP GUIDE

GE® MWF, GWF, GWFA, GWF01, GWF06, MWFA, WR02X11020, WR02X11287,

WR02X11290, WR2M3552, WR97X10006 Hotpoint® HWFA, HWF, MWF, MWFA Kenmore®/ Sears® 9991, 469991, 46-9991, 9996, 469996, 46-9996

Refrigerator Filter

NSGEMW531

PACKAGE CONTENTS

• Refrigerator lter(s) (1 or 2 pack)

• Quick Setup Guide

GENERAL INSTALLATION GUIDELINES

• It is normal for black carbon particles to appear on the outside of your new lter during shipping. Simply wipe it away before installation.

• This water lter is designed to prevent leaks. Please twist in place securely to ensure a proper t.

1 Twist the old lter a quarter-turn counterclockwise. 2 Pull the lter straight down and discard. 3 Push the new lter up into the refrigerator until it stops. 4 Twist the lter a quarter-turn clockwise. 5 Run about two to three gallons of water through your refrigerator’s water

dispenser to remove air and loose carbon pieces. The water may be cloudy and sputter until the air is removed.

6 Reset your “change lter” indicator (if your refrigerator has one). See below.

BEFORE USING YOUR FILTER

If your refrigerator has a change lter indicator, reset it. See “Resetting your lter indicator” for instructions.

RESETTING YOUR FILTER INDICATOR

Note: These are the most common lter reset instructions. If the instructions don’t work

for your refrigerator brand, see the documentation that came with your refrigerator.

REFRIGERATOR BRAND

GE®or Hotpoint®

Kenmore®

INSTRUCTIONS

Press and hold the reset water lter button on the dispenser for three seconds.

The water lter reset for Kenmore refrigerators varies by model. See the documentation that came with your refrigerator.

Before using your new product, please read these

instructions to prevent any damage.

TROUBLESHOOTING

PROBLEM

My refrigerator is not dispensing water

My water dispenser is dripping

My water is cloudy or contains black carbon pieces

My new lter is making noises or sputtering

My water tastes bad

SOLUTION

• Make sure that the lter is securely connected to the receiver. Do not use tools to tighten the lter in place.

• Make sure that the water line to the refrigerator is turned on. The valve must be completely open for the refrigerator to receive water.

• Make sure that the refrigerator door is closed or the dispenser will not work.

• A few drops are normal. If the water is dripping constantly, have a service technician check your refrigerator’s water valve.

• Cloudy water is caused by microscopic air bubbles. Run two to three gallons of water from your dispenser to clear the air bubbles out.

• Black carbon pieces in the water are normal and appear with all carbon lters. Run two to three gallons of water through your dispenser to remove loose carbon pieces.

• Noises and sputtering are caused by trapped

air pockets. Run two to three gallons of water from your dispenser to push the air out.

• Please reinstall the new lter as instructed and make sure that the lter is securely connected to the receiver. Do not use tools to tighten the lter in place.

• If you do not use your water dispenser for more than four days, run two gallons of water through the dispenser before using it.

• Make sure that you replace your lter every three to six months to prevent bacteria growth.

System Model No.: EFF-6013S Replacement Filter No.: NS-GEMW531

Operating Specications:

Operating Temperature: 33°F-100°F (0.6°C-38°C) Working Pressure: 20 psi-100 psi (140 kPa-689 kPa) Rated Capacity: 300 gallons (1,137 litres) Flow Rate: 0.5 gpm (1.9 Ipm)

Substance Reduction:

The system has been tested and certied by the NSF International according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for the water leaving the system, as specied by NSF/ANSI Standards 42 and 53. While testing was performed under standard laboratory conditions, actual performance may vary.

NSF Specied

Substance

Chlorine Taste

Carbofuran 73 ug/L 73 ug/L ± 10% 98.40% 2 ug/L 40 ug/L N/A J-00268284 Lead (pH 8.5) 140 ug/L 140 ug/L ± 10% 99.60% 0.5 ug/L 10 ug/L N/A J-00268279 Lead (pH 6.5) 140 ug/L 140 ug/L ± 10% 99.60% 0.5 ug/L 10 ug/L N/A J-00268280

Mercury (pH 8.5)

Mercury (pH 6.5)

CERTIFICATIONS:

Inf.

Average

1.9 mg/L 2.0 mg/L ± 10% 95.70% 0.082 mg/L N/A ≥50% J-00295502

and Odor

15 ug/L 15 ug/L ± 10% 96.60% 0.5 ug/L 0.5 ug/L N/A J-00268283

Benzene

120,000

Cyst

oocysts/L

Endrin 6 ug/L 6 ug/L ± 10% 93.60% 0.3 ug/L 2 ug/L N/A J-00296278

6 ug/L

6 ug/L 6 ug/L ± 10%

REPLACEMENT

ELEMENT

minimum 50000 oocysts/L 1 oocysts/L N/A ≥99.95% J-00263594

Concentration

Challenge

6 ug/L ± 10%

Reduction

Tested and Certied by NSF International in Model EFF-6013S against NSF/ANSI Standards 42 and 53 for the reduction of the claims specied on the Performance Data Sheet.

Average

0.3 ug/L

Max Permissible

Product Water

Concentration

2 ug/L

Ave. %

Product Water Concentration

(%)

99.99%

92.30% 0.5 ug/L 2 ug/L N/A J-00326152

93.80%

NSF

Reduction

Requirements

N/A

NSF Test

Report

00268282

STORAGE AND MAINTENANCE

• Replace your lter every three to six months to prevent bacteria and fungus growth in your lter, supply lines, and storage tank.

• Stored lters do not expire. Keep your unused lters in a cool, dark, and dry place until you need them.

• If you do not use your water dispenser for more than four days, run two gallons of water before using it to prevent bad tasting water.

ONEYEAR LIMITED WARRANTY

For complete warranty, visit www.insigniaproducts.com.

CONTACT INSIGNIA

1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico) www.insigniaproducts.com

Made in China

V2 ENGLISH 19-0412