Inovonics Wireless 3B6T User Manual

Installation Guide Requirements – TRM Module

List of Applicable FCC Rules:

 Applicable FCC rules for Modular Transmitters are found in the Installation

Instruction Manual in the following locations:

 Page 1 - Compliance Requirements
 Page 2 - FCC and Industry Canada Compliance
 Pages 2 and 3 – FCC and Industry Canada RF Exposure Requirements

Summary of Specific Operation Use Conditions:

 See Installation Instruction Manual, page 4 – Special Instructions.

Limited Module Procedures:

 Not Applicable – Device is not approved as a ‘limited module’.

Trace Antenna Designs:

 Not Applicable – The trace antenna is located on the TRM module, not on the

host’s printed circuit board.

RF Exposure Considerations:

 Instructions are provided on pages 2 and 3 in the Installation Instruction Manual

under FCC and Industry Canada RF Exposure Requirements.

Antennas:

 See Installation Instruction Manual, page 4 – Special Instructions.

Installation Guide Requirements – TRM Module (Continued)

Label and Compliance Information:

 Instructions for end-device product labeling are found in the following locations

in the Installation Instructions:

o Page 2 under Compliance Requirements and FCC and Industry

Canada Compliance

o Page 4 under Special Instructions.

Information on Test Modes and Additional Testing Requirements:

 Instructions relating to ‘Additional Testing Requirements’ are found on page 1

under Compliance Requirements.

Additional Testing, Part 15 Subpart B Disclaimer:

 Statement found in the following location in the Installation Manual: Page 1

under Compliance Requirements.