QSR Performance Solutions Drive Thru System - Installation Instructions
What Is Included
1 — Base Station w/ 13.5 VDC power adaptor
1 — Programming station w/ 18” cable
1 — Microphone for inbound audio
1 — Speaker for outbound audio
1 Lot — Acoustic foam for speaker post
Varies Per Order — Belt-packs w/ pouch
1 — Battery per Belt-Pack (w/1 additional battery when 4 or more belt-packs are ordered)
Varies Per Order — Headsets (1 per belt-pack)
1 — Battery charger w/ 5 VDC power adaptor
What Is Not Included
• Cable to connect Base to speaker post equipment (3 separately jacketed, shielded, twisted pairs,
minimum 20 gauge stranded)
• Vehicle detection loop
• Optional grill speaker (8 ohms)
• Speaker post
• Conduit from inside restaurant to speaker post
• Miscellaneous hardware
• Tools
Installation Steps
1. Begin charging batteries prior to installing system
2. Determine best location for Base
• Needs electrical outlet (power adaptor has 6 foot cable)
• Maintain 3 feet clearance from large metal objects and electrical or electronic equipment
• Relative close proximity to drive thru booth(s) but avoid installing where base cannot be ser-
viced without interrupting normal business operations
• Be mindful of where conduit to speaker post terminates inside
• Programming station connects to base with 18” cable and needs to be at a height and location
that is accessible to restaurant employees
3. Install cabling from speaker post to Base location. 3 individually shielded, jacketed, twisted pairs, minimum 20 gauge stranded.
4. Mount Base and connect cables (keep power cable and transformer at least 6 inches from left side of
Base)
5. Mount programming station within 18” of Base, and at an accessible height and connect cable
6. Mount vehicle detector and connect to Base, and to cable feeding to loop at speaker post
7. Install speaker and microphone in speaker post and connect cables, including connection to vehicle
detector loop. Solder all splices.
• IMPORTANT! Speaker and microphone inside of speaker post MUST be acoustically and me-
chanically isolated from each other AND the speaker post with foam rubber or an acoustic
dampening material to insure quality audio performance.
• In a typical speaker post the microphone would be mounted in the top section, closer to the
person placing the order. The speaker should be at least 2 feet away from the microphone,
typically mounted lower.
1
Installation Steps — cont.
8. Make sure jumpers in Base are configured to match your installation (see Base Station Controls dia-
gram)
• J1 & J2 — Separate speaker & mic or one device serving as both
• J4 — Detection type: closure or pulse
• J5 — Full-duplex or Standard (half-duplex)
• J6 — Full-duplex click suppression
9. Turn on power to base
10. Insert batteries in belt-packs and program per instructions on programming station
11. Connect headsets to belt-packs and test range, reception, audio quality, and volume
12. Adjust volume levels as needed
13. Test vehicle detection
14. Train restaurant employees and manager
QSR Drive Thru Solutions - Batteries & Charger
Holes for Wall
Mount Screws
NOTES:
• Batteries are Lithium-Ion
• Batteries require about 3 hours to charge
• Batteries will hold a charge for about 8 to 10 hours during normal use
• When the battery voltage becomes too low, a short warble tone, occurring at five–second
• Batteries should be removed from belt-pack and stored in charger when not being used.
Charging Indicators — Will light red
when battery is charging and change
to green when battery is charged
Charging Ports for
Batteries
intervals is heard in the headset. After 2 minutes the headset will shut off.
2
Loading...