INOR IPAQ-4L Operating Manual

The Transmitter Company

Intelligent
universal

Product group E

Nr 86BIQ00007 96 03 13

User instructions

WW

AA

WW

AA

AA

RR

RR

55

RR

RR

AA

NN

TT

YEAR

NN

YY

YY

TT

4-wire transmitter

PO Box 9125, S-200 39 Malmö, Sweden
Tel + 46 40 31 25 60, Fax + 46 40 31 25 70

Measuring is our business

1

General information

IPAQ-4L is a 4 wire transmitter
intended to be used in industrial
environment.

The transmitter is configured from
a standard IBM compatible PC by
using the IPRO software version

3.06 or later. When the transmitter
is set from a PC no calibration is
needed.

Configuration

If IPRO (the IPAQ software) isn't
installed in your PC, install the
software (follow the instructions in
"IPRO User instructions").

Configuration from PC is "on-line",
that is, the transmitter can be
installed in the process with input
connected during configuration.
The output is frozen while trans­mission from PC to IPAQ take
place. When transfer is done the
transmitter uses the new parame­ters.

The IPAQ-4L must be powered,
when you confiugre the transmit­ter, see figure 13.

NOTE: The label on the transmitter
indicate allowed power supply to
the transmitter. By connecting
false power supply the transmitter
may be damaged.

Connections

1. Power supply is connected
according to figure 13. Use the
power supply indicated on the
transmitter.

2. Input signal is connected
according to figure 1-10.

3. Output signal is connected
according to figure 11-12.

2

INPUTS

RESIST ANCE THERMOMETERS

Pt100, Pt1000, Ni100, Ni1000

4-sensor wires

3-sensor wires

Pt100 Pt100

3-sensor wires

Diff temperature

T1>T

2

Fig 1 Fig 2

THERMO COUPLE

AE,B,E,J,K,L,N,R,S,T,U

or custom specified

- +

*Smart Sense wire

Fig 5

VOLTAGE CURRENT

millivolt volt mA

- +

Fig 8 Fig 9

OUTPUTS

T

2

*Smart Sense
wire

Fig 3 Fig 4

POTENTIOMETER

4-sensor wires 3-sensor wires

Fig 6

Fig 7

- +

Fig 10

POWER SUPPL Y

T

1

Voltage Current

Fig 12Fig 11

Fig 13

3

Extensible holder for wall
mounting

35

99

Fig 14 Fig 15 mm

22,5

80

Short form data:

Power supply: 90-250 V AC or 20-30 VDC

(allowed power is indicated

on the transmitter).
Ambient temperature: -20 - 70°C
Isolation /input/ouput/power 4000 VAC
Typical accuracy 0.2 %
Mounting Rail, DIN50022

9082

4

PO Box 9125, S-200 39 MALMÖ, Sweden
Tel + 46 40 31 25 60, Fax + 46 40 31 25 70

All information subject
to change without
notice.