QUICK START INSTRUCTIONS FOR INOR USB SOFTWARE INSTALLATION
Follow these simple instructions for a successful install
Do not plug in the cables to your laptop or PC- 1st install the software (Drivers could go
in wrong- but this can be fixed).
Follow the sequence, steps 1 and 2, shown in the below window. Then install the
application software, like IPRO 4.32 or MinIPAQ SOFT 1.24.
Plug the interface cable and interface into the PC. Confirm that new hardware is found
and installed.
Plug in the transmitter (and if IPAQ-H/ L; IPAQ-4L; or any other TX that programs with
IPRO 4.32) the unit must be powered during configuration. [Except IPAQ=H+ / L+]
Double click on ConSOFT V2 shortcut on desktop.
Close instruction box and read from transmitter (ConSOFT is figuring out which
application software to open).
Use the application software to program the transmitter.
DONE.
3-11-2014
Loading...