Page 1
Instruction Manual
Please read this instruction manual carefully
before use and keep for future reference.
Bluetooth® Earbuds
Model: ITEB-100B (S301)
Page 2
BASIC OPERATION & FEATURES
Basic Operation
**You must fully charge the headset before use!**
POWER ON: Press & Hold Power Button.
Listen for “Power On, Pairing” audible prompt.
POWER OFF: Press & Hold Power Button.
Listen for “Power Off” audible prompt.
Features
NOTE: Parts of the Earbuds are magnetic, metallic material may be
effected.
DO NOT place credit cards or other magnetic storage
devices in close proximity to avoid erasing stored information.
LEFT
1
POWER /
SYNC BUTTON
CHARGING
PORT
VOLUME UP /
FAST FORWARD
POWER / BLUETOOTH
CONNECTION INDICATOR
VOLUME DOWN /
REWIND
Page 3
2
PAIRING & CONNECTING TO BLUETOOTH
-Activate the Bluetooth Feature on your device.
-Press & Hold Power Button. Listen for “Power On,
Pairing” audible prompt. The Bluetooth Connection
Indicator light will begin to ash RED & BLUE.
-Select “S301” on your device list. Listen for
“Connected” audible prompt.
Use password “0000” if required.
-Short press the Power Button to Play/Pause audio.
-Press Volume Up (+) on RIGHT earbud to increase
volume. NOTE: At max volume you will hear an
audible tone. To increase Earbud volume further,
raise the volume on your connected device.
Press & Hold to fast forward to the next song.
-Press Volume Down (-) on RIGHT earbud to
decrease the volume. Press & hold to rewind
current song. Press and hold again to rewind to
previous song.
-To disconnect, POWER OFF Earbuds or
disconnect your earbuds from your device.
Page 4
3
BATTERY CHARGING
When Bluetooth Connection Indicator ashes RED
with a beep and low battery audible prompt, battery
is low. NOTE: Earbuds will power off automatically
with continued use.
1. Insert plug of the charger cable into Earbud jack.
2. Plug the charger into a USB port (laptop, AC
adapter). Bluetooth Connection Indicator
will
illuminate RED. A full charge takes approximately
2 hours. RED Indicator light will
change to BLUE
when Earbuds are fully charged.
3.
Disconnect charger from Earbuds and power
source. NOTE: Fully charged Earbuds can
support up to
2-6 hours of talk time and 100-180
hours of standby
time. When earbuds are
not
in use for an extended amount of time, store
in
a dry place and recharge every two months.
Caution: The built-in rechargeable battery is not replaceable. Do
not
remove or replace it, do not throw in the trash or in a fire. Do not
dispose device in standard garbage disposal sites. Dispose of device
at available Battery Recycling Sites after fully discharging
battery. Not
doing so may violate local disposal laws and regulations.
Please refer
to local regulations for proper battery disposal.
Page 5
4
HEADSET FEATURE
To Answer or End a Phone Call:
Apply a short press to the Power / Sync Button
to answer, apply the same short press to end call.
To Redial the Last Number:
When in Standy-by mode, apply 2 short presses
to the Power / Sync Button to redial the last call.
Activate Voice Dialing:
Press and Hold Power / Sync Button until your
device alerts you for a voice command.
Call Waiting:
Option 1: Press Power Button once to end the
rst call and answer the incoming call.
Option 2: Apply a long press to the Power
Button to reject the incoming call.
Option 3: Two short presses of the Power
Button puts the rst caller on hold to answer
the incoming call. Two short presses will allow
you to switch between callers (with one on hold)
.
Page 6
5
IMPORTANT INFORMATION
FCC Statement
Warning: Changes or modications to this unit not
expressly
approved by the party responsible for compliance
could void
the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply
with the limits for a Class B digital device, pursuant
to Part
15 of the FCC Rules. These limits are designed to
provide
reasonable protection against harmful interference
in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment
and receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
Page 7
6
WARRANTY
Innovative Technology Electronics Corp.
Limited Warranty: 90 Days Labor, One Year Parts
Innovative Technology Electronics Corp. (IT) warrants the product to be
free from “Defects” in materials under normal use for a period of “One
Year” from the date of the original purchase. The Warranty is “Not”
transferable. IT agrees, within the initial “90 Day” period, to repair or
replace the product if it is determined to be defective at “No Charge”. It
is further agreed that IT will cover the cost to repair or replace damaged
“Parts” only for a total period of “One Year” from the date of the original
purchase. The warranty does not cover cosmetic damage, antennas,
AC cords, cabinets, headbands, ear-pads, or damage due to line power
surges, connection to improper voltage supply or settings, misuse,
mishandling, accident, acts of God or attempted repair by an
unauthorized service agent.
To obtain service, the purchaser MUST present an original sales
receipt / proof of purchase. Please contact us at
www.ithomeproducts.com to request an RMA (Return Material
Authorization) number to return products for service or
replacement. Returns without an RMA number on the package will be
refused and returned to sender. Upon receipt of the returning item and
our full inspection (IT) may issue a replacement to customer for the
same item or of one that has equivalent value and features. To return an
item, supply full name, return address, phone number, item purchased,
receipt of purchase and reason for return to obtain RMA number.
All returns must be in the original packaging or reasonable substitute to
prevent damage. Customer “Must” include full name, shipping address
and telephone number inside of package. No return will be shipped
back to a PO Box or APO address.
Please include your check or money order in the amount of:
Page 8
7
• USD$5.00 for items $10.00 to $39.99 (Price Paid Per Unit)
• USD$10.00 for items $40.00 to $99.99. (Price Paid Per Unit)
• USD$16.00, for items $100.00 and up. (Price Paid Per Unit)
• Shipping fees are non-refundable
to be payable to Innovative Technology Electronics Corp. (for handling
and
return shipping charges) (IT) will not be responsible for delays or
unprocessed
claims resulting from a purchaser’s failure to provide any /
all of the necessary information. Send all inquiries or RMA request via
our website www.ithomeproducts.com/support.
Innovative Technology Electronics Corp.
1 Channel Drive, Port Washington, NY 11050
Toll free: 1-877-483-2497
Website for support: www.ithomeproducts.com/support
There are no express warranties except as listed above.
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY
IS THE EXCLUSIVE REMEDY OF THE CUSTOMER, (IT) SHALL NOT BE
LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR
BREACH OF ANY EXPRESS OR IMPLIED WARRANTY ON THIS
PRODUCT EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE
LAW. ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED IN
DURATION TO THE DURATION OF THIS WARRANTY. Some states do
not allow the exclusion or limitation of incidental or consequential
damages, or limitations on how long an implied warranty lasts, so the
above exclusions or limitations may not apply to you. This warranty
gives you specific legal rights and you may also have other rights, which
vary from
state to state.
Made in China.
Loading...