InnoMedia MTA6328-2Re Setup Manual
Copyright VoIP Much Phone Company Inc., 2015
Innomedia ATA’s
MTA6328-2Re
Innomedia ATA’s
MTA6328-2Re
VoIP Setup Guide
Visit http://www.innomedia.com for device manual.
Copyright VoIP Much Phone Company Inc., 2015
Innomedia ATA’s
MTA6328-2Re
Step
Action
1
Open your web browser and enter the IP
address of the SIP Device.
192.168.99.1 is the default address.
2
Enter your Username and Password.
NOTE:
The default User Name is "Admin" and
Password is "password". For security reason,
it is recommended to change the
default Administrator ID and Password after
initial login
Logging In
To login the Web User Main page, follow these steps
Copyright VoIP Much Phone Company Inc., 2015
Innomedia ATA’s
MTA6328-2Re
Step
Action
1
Open your web browser and connect to your
SIP Device.
2
Click VoIP, and then Profile Config.
3
Click on the profile tab to display the profile
setting on the
Screen.
4
Under Profile Information:
Enter the Profile name (optional).
Enter the SIP Proxy IP address.
Enter the SIP Local Signaling Port
number (default is 5060) .
Check Enable Outbound Proxy (if you
want this SIP proxy to be used as an
outbound proxy).
Enter the SIP Domain
NOTE: If the profile name is not configured,
the SIP Device will use the profile number as
the profile name.
5
Under Preferred CODEC:
Enter the Packetization time: 20
Select the preferred CODEC from the
drop-down box.
o PCMU/8000
o G729/8000 (if available)
o G729A/8000
6
Click Save to save your changes to the SIP
Device.
Profile Config
Go to the VoIP -> Profile Config tab of your device admin portal (left menu).
Enter the SIP Proxy value (from the SETUP document provided by VoIP Much)
Loading...