
User manual LPM Basisstation Ser.1
Basisstation LPM Basisstation Ser. 1
power supply: 100 - 240VAC / 50 - 60Hz
power: 12 W
transmission power:: 25mW EIRP
transmission frequency: 5,725 – 5,875 GHz, licence-free ISM
Band
data transfer to the LPM server LWL Multimode
dimensions: 197 x 138 x 70mm
weight: 1,6 kg
type of protection: IP65
antenna: Patch: 65°h / 35°v / 11dBi
The base station measures the time differences of transponders and base station
followed by transmitting them to the Hub (Multiplexer). The base stations has to be
installed by the supplier.

This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected
- Consult the dealer or an experienced radio/TV technician for help.
inmotiotec GmbH
Local Position Measurement
Premium BS V23Product
Premium BS V23Product
123456Serial no.
123456Serial no.
110 -230VACPower supply
110 -230VACPower supply
25mW EIRPTransm. power
25mW EIRPTransm. power
ISM 5,8GHzFrequency
ISM 5,8GHzFrequency
FCC ID: 2AATD-PremiumBSV23
FCC ID: 2AATD-PremiumBSV23
The device complies with part 15 of
The device complies with part 15 of
the FCC Rules. Operation is subject
the FCC Rules. Operation is subject
to the following two conditions: (1)
to the following two conditions: (1)
This device may not cause harmful
This device may not cause harmful
interference, and (2) this device must
interference, and (2) this device must
accept any interference received,
accept any interference received,
including interference that may cause
including interference that may cause
undesired operation.
undesired operation.

Safety Precautions for technical personal:
Follow the instructions below to prevent damage to the device and the risk of
fire or electric shock:
• Use the power adapter supplied with the unit and plug it into a suitably
rated power outlet.
• Leave sufficient space around the device to allow the free flow of air for
heat dissipation. Do not cover the device as this will result in the device
overheating.
• Do not install in a damp environment or allow fluid to spill on the device
or Power Supply.
• Install on a stable surface.
Support:
Telefon: 0043 7672 27720 – 0
Web: http://www.abatec-ag.com/inmotiotec-rtls/