Inglis IJ40001, IJ41001, IJ42001, IJ43001, IJ44001 Installation Guide
...
IMPORTANT:
Read and save
these instructions.
IMPORTANT:
Installer: Leave Installation Instructions with
the homeowner.
Homeowner: Keep Installation Instructions
for future reference.
Save installation Instructionsfor local
electrical inspector's use.
Part No. 3361044
Washer
Beforeyoustart...
Check locationwhere washer will be installed.
Proper installation is your responsibility.
Make sure you have everything necessary
for correct installation.
Grounded electrical outlet is required.
See Electrical requirements.
Standpipe drain system: needs 5 cm (2")
minimum diameter standpipe with minimum
carry-away capacity of 65 liters (14 Imperial
gallons) per minute,Top of standpipe must
be at least 87 cm (34") high and no higher
than 183 cm (72")
from bottom of
washer, Do not tape
hose into standpipe
or close the standpipe
completely. An air
path is required to
prevent siphoning.
Floor drain system:
Requires a siphon
break, Part No.
285320, available
from authorized
distributors.
Untape and open washer lid.
Remove all material from washer.
Important: Observe all
governing codes and
ordinances.
Hot and cold water faucets: Must
be within 1.2 meters (4') of the back
of the washer and provide water
pressure 34 to 690 KPa (5-100 PSI).
Laundry tub drain system: Needs
a 75 liter (16.5 Imperial gallon)
laundry tub. Top of tub must be at
least 87 cm (34") high and no
higher than 183 cm (72") from
bottom ofwasher,
If a longer drain hose is needed,
a drain hose (Part No. 388423)
and hose extension kit (Part No.
285442) are available from
authorized parts distributors at
additional cost. If drain hose
muse be shortened, use kit
(Part No. 285442).
SEE RECESSED
AREA
INSTRUCTIONS
ON PANEL A.
ii i
Toolsneededfor /
installation
Utility
knife _\ Pliers
Wrench __
Padssuppliedfor
installation:
Remove parts from packages, Check
that all parts were included.
Level floor: Maximum slope under entire
washer - 2.5 cm (1").
Support: Floor must be sturdy enough to support
washer weight of 143 kilograms (315 Ib).
Electricalrequirements
!20-volt, 60-Hz, AC-only, 15 or 20
ampere fused electrical supply is
required. (Time-delay fuse or circuit
breaker is recommended.) It is
recommended that a separate circuit
serving only this appliance be provided.
Groundingmethod
Electrical Shock Hazard
• Electrical ground is required on
this appliance.
• Improper connection of the
equipment-grounding conductor
can result in fire, electrical shock
or other personal injury.
• Check with a qualified electrician
if you are in doubt as to whether
the appliance is properly
grounded.
• Do Not modify the power supply
cord plug. If it does not fit the
outlet, have a proper outlet
installed by a qualified
electrician.
• Do Not use an extension cord
with this appliance.
• Do Not have a fuse in the neutral
or grounding circuit. A fuse in the
neutral or grounding circuit could
result in an electrical shock.
Failure to follow these instructions
could result in a fire, electrical
shock or other personal injury.
Water heater: Set to deliver 60°C
(140°F) water to the washer.
Product Damage
Do Not store or operate washer
below 32°F (0°C) (some water may
remain in washer).
See Use & Care Guide for
"Winterizing" information.
Failure to follow above may result
in product damage.
Recommended
groundingmethod
For your personal safety, this appliance
must be grounded. This appliance is
equipped with a power supply cord
having a 3-prong grounding plug. To
minimize possible shock hazard, the
cord must be plugged into a mating
3-prong grounding-type wall receptacle,
grounded in accordance with the
appropriate Canadian Electrical Cedes,
and local cedes and ordinances, If a
mating wall receptacle is not available, it
isthe obligation of the customer to have
a properly grounded 3-prong wall
receptacle installed by a qualified
electrician. See Figure 1.
3-prong
3-prong grounding-
grounding type well
plug receptable
O
1 prong
_ Power
_J supply
cord
Figure I
1 small clamp 4 flat water hose
1 literature washers
package 2 front-leveling legs
1 drain hose with nuts
1 hose clamp
2 inlet hoses
PANEL B
Loading...