Installing SIM Card and Memory Card
1. Put the thimble tool into the hole near SIM card tray, then
push until card tray pop up, and then pull out the card with
hand.
2. Put the SIM1/SIM2 into the card slot or put the
SIM1/Memory card into the card slot as below picture:
Then push the tray into the phone card slot.
Charging the Battery
Before using the phone, it is recommended to fully charge
the battery first.
1. Connect the smaller end of
the USB cable to the USB port
of the device.
2. Connect the other end of the
cable to the AC adapter or other
USB port with power source
(for example, laptop).
3. Plug the AC adapter to a wall
outlet to start charging.
SAR Information
THIS MOBILE DEVICE MEETS GUIDELINES FOR
EXPOSURE TO RADIO WAVES. Your mobile device is a radio
transmitter and receiver. It is designed not to exceed the limits
for exposure to radio waves recommended by international
guidelines. These guidelines were developed by the
independent scientific organization ICNIRP and include safety
margins designed to assure the protection of all persons,
regardless of age and health.
The exposure guidelines for mobile devices employ a unit of
measurement known as the Specific Absorption Rate or SAR.
The SAR limit stated in the ICNIRP guidelines is 1.6 W/kg
averaged over 1 grams of tissue. Tests for SAR are conducted
using standard operating positions with the device transmitting
at its highest certified power level in all tested frequency bands.
The actual SAR level of an operating device can be below the
maximum value because the device is designed to use only the
power required to reach the network. That amount changes
depending on a number of factors such as how close you are
to a network base station. The highest SAR value under the
ICNIRP guidelines for use of the device at the head is
0.415W/kg and at the body is 0.468W/kg (The measure
distance of 5 cm).Use of device accessories and
enhancements may result in different SAR values. SAR values
may vary de pending on national reporting and testing
requirements and the network band.
Important Safety Information
• Use a wireless hands-free system (headphone, headset) with
a low power Bluetooth emitter.
• Make sure the cell phone has a low SAR.
• Keep your calls short or send a text message (SMS) instead.
This advice applies especially to children, adolescents and
pregnant women.
• Use cell-phone when the signal quality is good.
• People having active medical implants should preferably keep
the cell phone at least 15 cm away from the implant.
RoHS Compliance
This product is in compliance with DIRECTIVE 2011/65/EU
OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL
of 8 June 2011,on the restriction of the use of certain
hazardous substances in electrical and electronic
equipment and its amendments.
E-Waste
Products are in conformity with the requirements of the
reduction of hazardous substances of the E-Waste rules 2016.
For the purpose of recycling to facilitate effective utilization of
resources, please return this product to a nearby authorized
Collection Centre, registered Dismantler or Recycler, or
Service Centre for disposing of this product.
To know more about safe and secure recycling and proper
disposal of end-of-life electrical and Electronic Products
Customer can contact our recycling partner on toll-free
numbers region wise at:
North India-1800-102-8632
South India- 1800-843-3303
East India- 1800-843-3301
West India-1800-843-3302
Email – info@3rrecycler.com
For more detailed information, see the User Guide.
www.infocusindia.co.in
Warning
• Charge only indoors and in dry environments.
• For safety, the overheat protection will be active during
charging. If the system temperature reaches above the
maximum level, thedevice will automatically stop charging. The
device will only resume
charging when normal operating temperature is reached.
• If there is no response after you press the power button or
touch the panel, press and hold the ‘power button and
volume (+) key’ for 10 seconds, phone will restart, and if you
hold the ‘power button’ for 10 seconds, it will restart too.
• InFocus standard for water ingression criteria.
(1) Water ingression label become red color or contaminated.
(2) Water marks or corrosions on device PCB or components.
• Please make sure the temperature for adapter will not be
higher than 40℃
• Do not store your phone in temperatures higher than 60℃
• The operating temperature for this device is from -10℃ to 40℃
WEEE Notice
The WEEE logo on the product or on its box indicates that this
product must not be disposed of or dumped with your other
household waste. You are liable to dispose of all your
electronic or electrical waste equipment by relocating over to
the specified collection point for recycling of such hazardous
waste. Isolated collection and proper recovery of your
electronic and electrical waste equipment at the time of
disposal will allow us to help conserve natural resources.
Moreover, proper recycling of the electronic and electrical
waste equipment will ensure safety of human health and
environment. For more information about electronic and
electrical waste equipment disposal, recovery, and collection
points, please contact your local city center, household waste
disposal service, shop from where you purchased the
equipment, or manufacturer of the equipment.
Do dispose according to the local laws and regulations of
your region IS 16333(Part 3) : 2016 compatible
Indian Language Support for Mobile Phone
(Model: IF9031)