SP-CEIL-LM770
LCD Projector MountLCD Projector Mount
INSTALLATION INSTRUCTIONS INSTALLATION INSTRUCTIONS
Step 1Step 1
Invert the projector and place it on a soft and flat surface.
Raise the two front feet. Locate the four (4) 4mm mounting
points found on the bottom of the projector and loosely secure
the two (2) 4mm quick release sleeves to the front of the
projector, secure with the two (2) 4mmx20mm phillip screws
(supplied). Align the key holes from the mounting bracket and
slide it through the quick release sleeves, the hinge pin
openings should face the lens of the projector. Push the
bracket backwards to align the rear 4mm points and secure
the bracket with the two (2) 4mmx10mm knurl knobs
(supplied) tighten the quick release sleeves.
See Figure 1
Step 2Step 2
Install the base box securely to the ceiling structure in
accordance with proper commercial standards. Use
(commercially available) suitable hardware depending
on the installation requirements.
NOTE: If the SPSP-- LTMTLTMT-- EXTEXT adjustable height
suspension adapter is a part of the installation, securely
install the ceiling adapter to the ceiling at this time.
(Refer to its installation instructions).
Step 3Step 3
Install the two (2) hinge pin bolts loosely on both sides of
the base box. Raise the projector with the mounting
bracket attached and slip though the hinge pin slots
openings on the bracket into the base box. Install the two
(2) angle locking bolts. Adjust the angle, lock it, and then
tighten the hinge pin bolts. See Figure 2
Step 4Step 4
Check all the hardware for proper tightness and security. Do
not over tighten hardware.
Note:Note: Projector can be removed quickly for portable use by:
(1) Remove the knurl knobs. (2) Hold the projector with two hands
and slide it backwards to detach the sleeves from the
keyholes.(Reverse the process for quick reinstall)
Step 5Step 5
Raise the projector with the mounting bracket and slip through
the hinge pin slot openings on the bracket into the base box.
Loosely install the two hinge pin bolts, spacers and washers and
the angle locking bolts. Adjust the angle and lock it. Then tighten
the hinge pin bolts. See Figure 3
The ceiling should be capable of supporting a weight of
at least five (5) times the projector(s) or
monitor(s)weight. If it cannot, the ceiling must be
reinforced. Proper installation procedure by qualified
personnel as outlined in the installation instructions
must be adhered to. Failure to do so could result in
serious personal injury.
DESCRIPTION/HARDWAREDESCRIPTION/HARDWARE
A. Projector
B. 4mmx20mm Phillip Head Screws (2ea.)
C. 4mm Quick Release Sleeves (2ea.)
D. Front Feet (Raise 3/8” from the projector)
E. 4mmx10mm Knurl Knobs (2ea.)
F. Projector Mount (1ea.)
G. Ceiling Structure
H. Conical Spacer (2ea.)
I. 6mm Flat Washer (2ea.)
J. 6mmx12mm Hinge Pin bolts (2ea.)
K. 6mmx12mm Angle Locking Bolts (2ea.)
L. PBB-12L Base Box
M. SP-LTMT-EXT
27700B S.W. Parkway Ave.
Wilsonville, Oregon 97070-9215
Phone 1-800-294-6400 Fax
www.infocus.com
Loading...