D
E
E
K
L
F
E
D
F
E
D
F
B
C
E
G
H
I
J
B
A
C
SP-CEIL-012
Projector Mount
Step 1
Invert the projector and place it on a soft and flat surface. Locate the three
(3) 6 (mm) mounting points found on the bottom of the projector. Secure the
mounting bracket using the three (3) 6 (mm) x 12 (mm) phillip screws
(supplied).
Do not over tighten the screws!
See Figure 1
Step 2
Install the base box securely to the ceiling structure in accordance with proper
commercial standards. Use (commercially available) suitable hardware
depending on the installation requirements.
NOTE
:
If the (Optional) AST-2446 adjustable height suspension adapter
is a part of the installation, securely install the ceiling adapter to the
ceiling at this time.
(Refer to its Installation Instructions)
Step 3
Install the two (2) conical spacers and two (2) flat washers two, (2) hinge pin
screws loosely on both sides of the base box. Raise the projector with the
mounting bracket attached and slip though the hinge pin slots openings on the
bracket into the base box. Install the two (2) angle locking screws, adjust the
angle, lock it, and then tighten the hinge pin screws.
See Figure 2
Step 4
Check all the hardware for proper tightness and security. Do not over tighten
hardware.
E
D
F
G
H
I
J
C
B
K
L
Step 5
Install the two (2) conical spacers and two (2) flat washers, two (2) hinge pin
screws loosely on both sides of the base box. Raise the projector with the
mounting bracket attached and slip though the hinge pin slots openings on the
bracket into the base box. Install the two (2) angle locking screws, adjust the
angle, lock it, and then tighten the hinge pin screws.
See Figure 3
Check all the hardware for proper tightness and security.
The ceiling should be capable of supporting a weight of at least 40 lbs
max, the weight of the projector. More than 40 lbs, the ceiling must be
reinforced. Proper installation procedure by qualified personnel as
outlined in the installation instructions must be adhered to. Failure to
do so could result in serious personal injury.
DESCRIPTION/HARDWARE
27700B S.W. Parkway Ave.
Wilsonville, Oregon 97070-9215
1-800-294-6400
www.infocus.com
For further information or ordering assistance
contact us at the phone/address number shown on
the front of this page.
A
. M6 x 12 Phillip screws (3)
B. SP-CEIL-012 mounting bracket (1)
C. Projector (not supplied)
D. Ceiling structure (see warning)
E. Suitable hardware (commercially available)
F. PBB-10RL base box (1)
G. M6 x 12 Angle locking screws (2)
H. M6 x 12 Hinge pin screws (2)
I. Flat washers (2)
J. Conical spacers (2)
K. AST-2446 Height suspension post (optional)
L. Height adjustable screws
Loading...