InFocus SP-CEIL-001 User Manual
SP-CEIL-001
Projector Mount
INSTALLATION INSTRUCTIONS
Step 1
Invert the projector and place it on a soft and flat surface.
Locate the three (3) 4 (mm) mounting points found on the
bottom of the projector (C). Secure the two (2) Quick release
sleeves (B) with the two (2) 4 (mm) x 20 (mm) Phillip Screws (A)
(supplied). Align the keyhole openings from the mounting
bracket (E) to the sleeves (B) and secure the bracket with the
4 (mm) x 16 (mm) knurl knob (D) (supplied).
Do not over tighten!
See Figure 1
Step 2
Install the base box securely to the ceiling structure in
accordance with proper commercial standards. Use
(commercially available) suitable hardware depending on the
installation requirements.
NOTE: If the (Optional) SP-LTMT-EXT Adjustable height
suspension adapter is a part of the installation, securely install
the ceiling adapter to the ceiling at this time.
(Refer to its Installation Instructions)
Step 3
Install the two (2) conical spacers (K) and two (2) flat washers (J) two
(2) hinge pin screws (I) loosely on both sides of the base box (L). Raise
the projector with the mounting bracket attached and slip though the
hinge pin slots openings on the bracket into the base box. Install the
two (2) angle locking screws (H) adjust the angle, lock it, and then
tighten the hinge pin screws (I).
See Figure 2
Step 4
Check all the hardware for proper tightness and security. Do not
over tighten hardware.
Step 5
Install the two (2) conical spacers (K) and two (2) flat washers (J) two
(2) hinge pin screws (I) loosely on both sides of the base box (L). Raise
the projector with the mounting bracket attached and slip though the
hinge pin slots openings on the bracket into the base box. Install the
two (2) angle locking screws (H) adjust the angle, lock it, and then
tighten the hinge pin screws (I).
See Figure 3
Check all hardware for proper tighten and security.
The ceiling should be capable of supporting a weight of
at least five (5) times the weight of 19 Lbs. If it cannot, the
ceiling must be reinforced. Proper installation procedure
by qualified personnel as outlined in the installation
instructions must be adhered to. Failure to do so could
result in serious personal injury.
DESCRIPTION/HARDWARE
A. 4 (mm) x 20 (mm) Phillip screws (2ea)
B. 4 (mm) Quick release sleeves (2ea)
C. Projector (Not Supplied)
D. 4 (mm) x 16 (mm) Knurl knob (1ea)
E. SP-CEIL-001
F. Suitable Hardware (Commercially Available)
G. Ceiling Structure (See Warning Label)
H. 6 (mm) x 12 (mm) Angle locking screw (2ea)
I. 6 (mm) x 12 (mm) Hinge pin screw (2ea)
J. Flat washers (2ea)
K. Conical spacer (2ea)
L. PBB-10RL Base box/Jam screw (1ea)
M. Suspension Adapter Adjustable Pins (2ea)
N. SP-CEIL-EXT Adjustable suspesion Adapter (Optional)
For further information or ordering assistance
contact us at the phone/address number shown
on the front of this page.
27700B S.W. Parkway Ave.
Wilsonville, Oregon 97070-9215
Phone 1-800-294-6400 Fax
www.infocus.com
Loading...