Infocus RP10S, RP10X User Manual

LP280-LP290-RP10s-RP10x / Lamp Replacement

How do I install a new lamp? How do I reseat the current lamp?

1. Turn the projector off and unplug it. Let it cool for 60 minutes.

2. Turn the projector upside down on a flat surface.

3. Loosen the three captive screws the fasten the lamp module to the projector.

4. Lift the lamp module out of the projector. Dispose of the old module in an environmentally repsonsible

manner.

5. Insert the new lamp into the projector, making sure that the connector inside fully engages.

6. Tighten the three screws.

7. Plug the power cord in and turn on the projector.

How do I reset the lamp timer?

On the projector keypad, press the Menu button. Navigate to Basic > Setup > Service. Select Reset Lamptimer,
then press the Source/Select button. When the Lamp Change window appears, click the Source/Setup button
again to reset the timer. You can do this prior to 2,000 hours.