InFocus M2 Quick Start Manual
Quick Start Guide
1
Introduction
Thank you for choosing InFocus M2 phone. It is
recommended that you first read this
Quick Start
Guide
to understand the basic operation of the
phone.
Content
Your Phone ............................................... 2
Installing SIM Card(s) and Memory Card .. 3
Charging the Battery ................................. 4
Initial Start Up ............................................ 4
Home Screen ............................................ 4
Making Your First Call ............................... 5
Contacts .................................................... 6
Sending a Text Message ........................... 7
Setting up WLAN ....................................... 7
Setting up Email Account .......................... 8
Sending and Receiving Emails .................. 8
Using Browser ........................................... 9
Using Bluetooth ....................................... 10
Taking Photos and Videos ...................... 10
Viewing Photos and Videos ..................... 12
Basic Phone Settings .............................. 13
2
Your Phone
Power button
Microphone
Rear camera
Flash
Speaker
Headset jack
Earpiece
Flash
Volume (+/-) button
Touch screen
Microphone
Micro USB port
Front camera
LED Light Indicator
3
Installing SIM Card(s) and
Memory Card
1. Place your phone face
down on a flat surface.
2. Starting from the slot
on the lower-left
corner, release the
latches on the bottom
cover and remove the
cover.
3. Insert the SIM card(s)
into the slot(s) as
illustrated.
NOTE:
• To remove the SIM card,
push the SIM card firmly
into the slot first to eject
it, then pull it out.
• When using the card adapter (Nano SIM -> Micro
SIM), do not use excessive force to remove the SIM
card as this can damage the card.
• The SIM1 supports 3G and 4G data network.
However, the SIM2 only supports voice call.
4. Insert the memo ry
card into the slot with
golden connectors
facing up.
5. Replace the bottom
cover and press along
the edges until you
have a secure seal.
SIM2
SIM1
MICRO SD
SIM2
SIM1
MICRO SD
SIM2
SIM1
SD
SIM2
SIM1
MICRO SD
SIM2
SIM1
MICRO SD
SIM2
SIM1
MICRO SD
SIM
MICRO SD
SIM2
SIM1
MICRO SD
4
Charging the Battery
Before using the phone, it is recommended to fully
charge the battery first.
1. Connect the smaller end of the
USB cable to the USB port of
the device.
2. Connect the other end of the
cable to the USB charger or
other USB port with power
source (for example, laptop).
3. Plug the AC adapter to a wall outlet to start
charging.
Warning
• Charge only indoors and in dry environments.
• For safety, the overheat protection will be active
during charging. If the system temperature reaches
above the maximum level, the device will
automatically stop charging. The device will only
resume charging when normal operating
temperature is reached.
• If there is no response after you press the Power
button or touch the panel, press and hold the Power
button for 8 seconds to force shutdown. If you hold the
Power button for 2 seconds more, it will restart.
Initial Start Up
After installing the SIM card(s) and charging the
battery, the device is ready to be used.
Home Screen
From the Home screen,
you can quickly access
common features and
view notifications of
missed calls, received
messages, check battery
and connection status.
Swipe your finger to the
left or right to access the
applications installed on
the device.
5
Making Your First Call
From the Home screen, tap .
To make a call
1. Enter the phone
number on the
keypad.
2. Tap to correct
any number. Tap
and hold to erase
the entire number.
3. Tap to make a
call.
4. To end the call, tap
.
NOTE:
If you have
inserted two SIM cards,
select the desired SIM
network.
To receive a call
To answer a call, tap and drag it to the right
().
NOTE :
When you tap , it automatically changes to .
6
Contacts
Adding contacts
1. From the Home screen, tap .
2. Tap to add a
contact.
3. Select one of the
location to store the
contact to.
4. Enter the contact
information such as
name, phone
number, email
address, etc.
5. Tap
Done
to save
the contact.
Importing contacts
1. From the Home screen, tap .
2. Tap >
Import/
export
, and choose
one of the
Jnqpsu
options.
3. Select the contacts
location that you
want to copy to.
4. Select the contacts
to copy and tap
Done
.
Loading...