Infocus LITEPRO 210, LP210 User Manual
009-0214-01
SAFETY SUMMARY
: Please
read these instructions before
using your LitePro 210. Failure to
comply could result in fire,
electrical shock, personal injury or
equipment damage.
Definition of Safety Icons
on Product Labels
Refer to the User’s
Guide for more
informat i on.
Avoid hot surfaces.
Bulb explos io n
haza rd.
Don’t Look Into The Lens!
Be extremely careful not to look directly into the lens when the 210 is on. The
bright light can harm your eyes. Be especially careful to keep children from looking into the lens.
Don’t Disassemb le
Do not open the 210 case! Doing so exposes you to an electric shock hazard.
Except for the projection lamp, there are no user-serviceable parts. All service
must be performed by an In Focus Systems Authorized Service Provider.
Avoid Hot Su rfaces
The inside of the 210 lamp housing can be very hot. Allow the 210 to cool for at
least 45 minutes before opening the lamp door to replace the lamp. Use extreme
care. Avoid touching the hot surfaces inside.
Use On ly T he 210 Power Cord
Always use the power cord that came with the 210. Although other cords might
look the same, they have not been safety-tested with the 210. Never use the power
cord if it’s damaged or frayed. When you disconnect the 210, always remove the
power cord from the electrical outlet first, then from the 210.
Don’t Defeat The Purp o se Of The Grounding Plug
The 210 is grounded through the grounding conductor on the power cord. To
avoid electric shock, plug the power cord into a properly wired receptacle.
Use The Correct Fuse
To avoid the risk of fire, use only a T6.3AH 250V 5x20mm fuse.
Avoid Liquid Spills
Don’t set drinks on top of the 210. Spilled liquids can flow inside causing damage.
Don’t Block Ventilation
Openings in the case provide ventilation to protect the 210 from overheating.
Keep loose papers and other objects away from the bottom, top and side grills.
Don’t place the 210 on top of or close to a computer or other heat-producing
equipment.
Loading...